Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Lets be careful out there, er in the shop.

Posts

Lets be careful out there, er in the shop.

#1

Lets be careful out there, er in the shop.

Barry Irby

Been working on the table I mentioned below. There was a second joint that had a crack near the end, but only about an inch long. While I was sanding I was pondering whether to rip the joint on my TS or Bandsaw, joint it and glue it again or perhaps just ignore it and consider it patina. I sanded the end of the panel and low and behold, a wiggly nail (corrugated fastener for the uninitiated) appeared. Glad I did not hit that with my Forrest blade. So, as Jeff Jewet said in the Article somebody post for me to read, be sure you inspect the joint VERY carefully before you work on it.