Has anyone replaced this themselves?
Barry Rubenstein
It's the fan shroud from the DW 735 planer. Really good machine, but lots of use caused this. Looks fairly easy to change out, but hoping for some feedback. thx
Knowledge You Can Build On — Est. 1998
Has anyone replaced this themselves?
Barry Rubenstein
It's the fan shroud from the DW 735 planer. Really good machine, but lots of use caused this. Looks fairly easy to change out, but hoping for some feedback. thx
Yes
JL
I had the joyous task of doing that a while back.
The outer screws are a PITA to get out. The inner screws holding the inner side of the housing are relatively easy to get out. My big problem was getting the little spring catch on the housing on the side towards the back of the planer fastened and unfastened.
I was surprised that the lip on the inside of the housing made such a difference. I was also surprised that it had worn away.
Get the parts from www.ereplacementparts.com
Craig
The parts cost less from www.ereplacementparts.com than ordering from DeWalt direct. Pretty quick shipping and the pieces went in without a huge hassle. Those screws are a pain though.
Craig
Re: Get the parts from www.ereplacementparts.com
Barry Rubenstein
Thanks for the feedback guys. About the difficult screws; am I correct that the yellow housing is not removed, making working the screws hard to deal with?
Re: Get the parts from www.ereplacementparts.com
Craig
Correct, the yellow housing is pretty complex and not worth taking apart.
Craig
Vacuuming sawdust out is essential
JL
as is lubricating the chain afterwards. I did remove the grill on the back side to allow access to the chain so I could vacuum out that area.
When the lip wears out, the chips really fly everywhere inside. I raised and lowered the body a couple of times to make sure I got all of the chips/dust. I raised and lowered again when lubricating the chain.