Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Repairing Failing Glue joint question

Posts

Repairing Failing Glue joint question

#1

Repairing Failing Glue joint question

Barry Irby

A family member has asked me to repair a table that was my Grand Mother's. I grew up with this table and my Grand Mother had it built out of walnut from the family farm. I am 63 and the table was there as long as I can remember. Its a drop leaf table and one of the joints in a leaf has partially failed. The joint is about four feet long and about 2/3's of it has come apart. How do I separate the rest of it? I have a heat gun. I was considering driving a soft wooden wedge into the joint to put the rest of the joint in tension and see if it just popped and then heating it if it did not. I guess I could just whack it?

Any suggestions?

Once I repair the joint, I will sand and refinish the entire table. It is somewhat care worn and has a water stain from a potted plant dead center of the top.

Any Idea what the glue might be? The residual squeeze out on the under side is sort of Ivory colored.

Re: Repairing Failing Glue joint question

#2

Based on the age,

Merle

I would guess hide glue which is reversible. Warm, moist heat should do the job. Another option would be to rip the top along the glue line, then reglue. I would not try to force the joint apart because you don't know where the resulting split might go.

Re: Repairing Failing Glue joint question

#3

Re: Repairing Failing Glue joint question *LINK*

Bob Entwisle in NJ

Hi Barry,

You might give this a read.

I'd not want to just wedge it apart in case the rest of the glue joint is solid which might cause the wood to split outside the glue line. I'd try to soften the remaining joint first, or at least get a feel for how solid it is.

Bob in NJ


http://www.woodcentral.com/bparticles/repair.shtml

Re: Repairing Failing Glue joint question

#4

Re: Repairing Failing Glue joint question

Dick Coers

I would suspect the entire joint is now sprung, and even if opened up and cleaned, it might not come together tightly. Without a picture,or straightedge, I would suggest you consider cutting it open on the bandsaw, then joint and reglue.