Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Refinishing exterior church doors (oak)

Posts

Refinishing exterior church doors (oak)

#1

Louie Lovas

Refinishing exterior church doors (oak)

Louie Lovas

Hi all, looking for advise on the following ...

I have been asked to refinish the doors of our church. They are big, heavy and old, quartersawn white oak.

The old finish it quite deteriorated, but not to the point to cause any major problems with the wood itself.

Anyway, I would very much like to do the right thing to restore them in a lasting manner. The building is over 100 years old, a beautiful granite stone structure. But the doors need help, see photos below.

Any suggestions, advice much appreciated.

Thank you,

Louie


img

Re: Refinishing exterior church doors (oak)

#2

Re: Refinishing exterior church doors (oak)

Jim Hoeller

Try a mix (50/50) of turpentine and boiled linseed oil in a small area. I used it on an oak exterior door in similar condition to the one in your post and was pleased with the result. I applied a heavy coat, let it sit and wiped off the excess. The turpentine cut through the dirt and the linseed oil became the first of four coats. Areas around the handle may need additional mix material to get them clean.

Re: Refinishing exterior church doors (oak)

#3

Clint Searl

Re: Refinishing exterior church doors (oak)

Clint Searl

Unless you want an aged patina look, I think they should be completely stripped and deep cleaned, followed by a high gloss marine varnish. They're too nice for anything else.

Re: Refinishing exterior church doors (oak)

#4

Re: Refinishing exterior church doors (oak)

Nat Robison

I remember seeing an article in Fine Woodworking (sometime in the last year) that deals with exactly what you want to do. I believe it dealt with stripping completely and refinishing with marine-grade varnish.

Re: Refinishing exterior church doors (oak)

#5

I wouldn't want to be the one

Merle

doing the work :) , but I agree with Clink and Nat. Strip them, then apply the best spar varnish you can find. Here is one good one that is highly recommended:

http://www.jamestowndistributors.com/userportal/show_product.do?pid=92&familyName=Epifanes+Gloss+Clear+Varnish

Re: Refinishing exterior church doors (oak)

#6

Re: Refinishing exterior church doors (oak)

Dick Coers

Oh man, i hate church work. You get to please a committee and the congregation. I pulled it off twice, but held my breath both times. I think those doors are going to need a 2 part bleaching if you ever want to try and reach an equal color all over. Those failed areas are going to finish as a different color if you don't do something. I have to tell the story of the second church project. Solid mahogany gothic arch doors were specified. I used some fantastic stock, and all were thrilled. The widow that put up the money in her husbands name, wanted them painted in BRIGHT RED PAINT! Yep, still red after 20 years!

Re: Refinishing exterior church doors (oak)

#7

Re: Refinishing exterior church doors (oak)

Roger Rayburn

And remember to show us some photos after you finish the project. These are beautiful doors. Can't wait to see the result of your efforts.

Re: Refinishing exterior church doors (oak)

#8

Jim DeLaney, Austintown, Ohio

Re: I wouldn't want to be the one

Jim DeLaney, Austintown, Ohio

Do what Merle said. Stripping and re-varnishing is the only way to do it right, and the Epifanes product he recommends is the best there is. Jamestown Distributors is a very reputable company, and that's where I buy my Epifanes.

Re: Refinishing exterior church doors (oak)

#9

Louie Lovas

Re: Refinishing exterior church doors (oak)

Louie Lovas

Thanks everyone for all the advise, very much appreciated.

I found an article in Fine Homebuilding about refinishing old doors.

I will take all your input plus what I can discover searching the internet to come up with a plan to present to the church 'committee'.

Considering the labor involved and the number of doors, this will probably take me all summer to get done :)

thanks again everyone,

Louie