Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Simple Box Question

Posts

Simple Box Question

#1

Simple Box Question

JohnT in MD

Wife asked me to make a simple box to carry a cast iron dutch oven for the Girl Scout troop's camping gear.

Started planning and measuring, then realized I didn't know which way would be best to orient the grain on the sides. I'm using 3/4 oak, and plan to have 4 solid sides and a bottom, with a slide off top, so you reach into the solid box to get the dutch oven.

I'll be using simple butt joints, glue and screws, for simplicity. Don't have the time/patience/skill to cut dovetails....

I'm overthinking this - everytime I think I've decided which way the grain should run on the sides, I come up with a reason why it should be the other way, and then another reason why I was right the first time...

I'm guessing it should be running horizontally on the 4 sides of the box, not vertically.

Boy, I feel dumb sometimes....

Thanks for any replies.

-John-

Re: Simple Box Question

#2

You got it right...

John in NM

Horizontally on the four sides. I would use a plywood panel for the bottom and maybe the top too.

You might consider making a rabbet joint for the corners, or a box joint if you have a table saw and dado blade. Butted with good screws should be fine too though, no need to get fancy if you're in a hurry.

Re: Simple Box Question

#3

Thanks, John

JohnT in MD

Thanks, John -

After thinking about it (again...) I figured a box joint would be better stregth-wise.

Thanks for the answer.

-John-

Re: Simple Box Question

#4

put a "dutchman" in the top


Re: Simple Box Question

#5

Bob

Re: Simple Box Question

Bob

If you are using 3/4" you could use box joints and they would never come apart. A sliding top is a good idea.

Re: Simple Box Question

#6

Re: Simple Box Question *LINK*

William Duffield

Chris Schwarz, who has probably built more tool boxes than anyone except Gerstner, and over-analyzes about what he is doing a lot, describes the construction methods you need in this blog post:

Screw this Anarchist’s Tool Chest Stuff