Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Bandsaw choice?

Posts

Bandsaw choice?

#1

Bandsaw choice?

Joe Pack

Which to choose? Used Rikon 10-325 14" that is perfectly serviceable , but probably could benefit from new bearings in the upper wheel and maybe new tires, or new Grizzly 0555LX 14". This saw would be used mainly with smaller blades (1/8 - 3/8) for more detailed cutting...boxes, figures, etc. and with the Carter stabilizer system. I already have a 16" for heavier cutting and resawing, but I'm tired of changing blades and making adjustments over and over.

The used Rikon will cost about the same as the new Grizzly.

Comments?

Re: Bandsaw choice?

#2

JL

Re: Bandsaw choice?

JL

I've used that particular Rikon over at the Folk School - I have its big brother sitting in my shop. I've also used an older version of that Grizzly at the Folk School.

The Rikon has a larger table. I also think that it has better dust collection - or at least it used to.

Bottom line - your choice. I think that both saws are good choices. I'd prefer the Rikon at bit more as it has a larger table and a larger motor - not that it matters for your application.

Re: Bandsaw choice?

#3

Re: Bandsaw choice?

Dick Coers

Tough choice, I vote Rikon. To sell a new saw at that price, you're not buying much for quality. I swore off anything with a cord from Grizzly based on a piece of junk bandsaw they sent me. The wheels were cast so poorly, they didn't have enough material to machine all around the face. So they drilled one side full of holes, and bolted on steel plates on the other side in an attempt to bring it to balance. They weren't successful. Then I ordered a second lathe chuck, after being happy with one I bought years ago. First one was a mess, I had to remachine the face of the jaws on the second one to have a flat surface. I won't be buying Grizzly, and can't recommend them.

Re: Bandsaw choice?

#4

Re: Bandsaw choice?

Larry Clinton At Frankfort, (Central) Indiana

Haven't had a Grizzly bandsaw, I had a Crapsman and then purchased a new MinMax about 5 years ago. But all the Grizzly products I have purchased have been more than satisfactory. I currently have their 8" joiner with segmented carbide cutters, and the 3 hp cyclone. Both work very well and are good quality machines. Don't know a lot about the Rikons or what their service is, Grizzly seems to have the best stock of parts and one of the best customer service organizations in the industry in my opinion.

Re: Bandsaw choice?

#5

Re: Bandsaw choice?

Jim B

I went up to Grizzly yesterday to buy a 14" bandsaw...could not pull the trigger...did not like what I saw. Today I went to Woodcraft to buy a Rikon 10-325 but they did not have any set up. They did have the Rikon 18" model but the upper wheel on that was all screwed up....I left in disgust....

Jim B

Re: Bandsaw choice?

#6

Re: Bandsaw choice?

Robert

I would stick with the Rikon. There have been a lot of complaints about Grizzly sending tools out with shippers that do not take care when handling, so equipment ends up arriving damaged, and then you have to fight to get replacement parts or a new machine. Besides, the Rikon has already been "broken in" for you!