Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Painted boards in jointer/planer

Posts

Painted boards in jointer/planer

#1

Painted boards in jointer/planer

Joe in a Cleveland suburb

How stupid would it be for me to put about 4 boards (about 3/4"x4"x4') that have latex paint on them thru my planer and jointer?

Both are due for new blades anyway.

Thanks in advance.

Re: Painted boards in jointer/planer

#2

Not stupid at all

Dustmaker Mike

I have done it a lot making signs I carve out the letters then paint the entire sign. I then pass it though my planer to clean off just the top. Works great.

Re: Painted boards in jointer/planer

#3

an alternative view

Bill Tindall, E.TN.

Paint is loaded with titanium dioxide which is highly abrasive. If the knife is traveling from within the board and then through the surface paint, abrasion will be minimized. This would be the case with paint only on the surface. However, if paint is on the edge, the knife will be traveling into the paint and I predict the paint on the edge will abrade a substantial groove into the knife.

Consider the cost and aggravation of sharpening knives and the cost of the lumber salvaged and then make the decision.

A wire brush on an angle grinder is effective for removing stufff on the surface of lumber.

Re: Painted boards in jointer/planer

#4

Re: Painted boards in jointer/planer

JMOHNIKE

If you have one use a hand plane first. Some times I find a nail or some other metal object. Easier to remove a nick from a hand plane blade than joiner blades.

Re: Painted boards in jointer/planer

#5

Re: Painted boards in jointer/planer

Norm Knoxville

Joe, I suggest you hit it with a coarse grit belt sander and then run them through your planner. Norm

Re: Painted boards in jointer/planer

#6

Re: Painted boards in jointer/planer

Robert Hayward

I suggest you hit it with a coarse grit belt sander

That is what I do with painted boards I want to reuse.

Bob