Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

bench top cross cut sled

Posts

bench top cross cut sled

#1

bench top cross cut sled

Jerry Gibbs

I have a 10" Ryobi bench top ts which I like. It serves my purpose. The miter gauge is flimsy. I want to build a cross cut sled. The miter slots are approximately 5/8" wide and 5/16" deep. I can make runners for these dimensions. The problem is that the slots have tabs on the top to form a sort of T track. The tabs create a problem for me to make a small or odd shaped runner. Do you think there is any problem removing the tabs? I could care less if Ryobi claims I made the saw dangerous. I also don't care about the miter gauge being contained by the tabs. Any suggestions for a sled are appreciated. I took a picture but I gave up trying to resize the photo. Jerry

Re: bench top cross cut sled

#2

Re: bench top cross cut sled

Paul Vander Woude

Why not just make the sled's runners to the dimension of the narrow, top part of the slot?

Re: bench top cross cut sled

#3

photo

Jerry Gibbs


Re: bench top cross cut sled

#4

Re: photo

Barry Irby

Can you find pieces of metal the "wider" width of the slot but thin enough to slide under those tabs? Then you could make some sort of stand offs to slide between the tabs.

Re: bench top cross cut sled

#5

Re: bench top cross cut sled

Robert Hayward

I would file off the eight ears and be done with it.

You could also mill the wood to the shape of the current miter slide.

Bob

Re: bench top cross cut sled

#6

Re: bench top cross cut sled

Robert Fuller

Those tabs are there for a reason (what it is is someone elses guess) so leave them be. Just make the runners the same (or similar) shape as the miter gauge. You did say the miter gauge was sloppy so maybe make the runners a bit larger and tweak their size till you get a tight fit that runs in the slot smoothly.