Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

sealing cracks in wood

Posts

sealing cracks in wood

#1

sealing cracks in wood

Mark M.

I'm in the process of making tabletops and coffee tables from tree trunks. After roughly 5-6 months of cureing the top surfaces were sanded to 220 grit and cracks filled with spar varnish mixed with sawdust and acraglass in other cracks. Most of the cracks are less than 1/8". Then 4-5 coats of spar varnish was applied sanding between each coat. Surfaces were then compounded and waxed to a nice sheen. It's been roughly 5 weeks and I'm noticing high spots over the filled cracks where apparently the filler expanded and dried. How can this be prevented as not to happen after the customer aquires the item? Should epoxy be used instead of varnish? Thanks in advance.

Re: sealing cracks in wood

#2

Re: sealing cracks in wood

paul in AZ

High spots over the filler or is the surrounding wood drying some more and shrinking?

Hard to imagine that an inert material like the crack filler would expand.

Re: sealing cracks in wood

#3

Re: sealing cracks in wood

Howard Acheson

It's likely not your filler that's expanding, rather it's the expanding/contracting of the wood as it gains and loses moisture due the the relative humidity in the area where it resides. This movement results in the filler being squeezed and causing it to be either above the surface or below the surfaceIt's is also may be that you wood has not fully dried yet.

On a related note, you don't say what the wood species is or how thick are the disks. As a general rule, it can take one to two years per inch of thickness for wood to fully dry. Folks who work with wood disks will treat the disks with chemicals to keep it from shrinking. You are likely to have more cracks and the ones you already have may get larger.

Re: sealing cracks in wood

#4

Re: sealing cracks in wood

John Lucas

Yea we need more info. Are you taking slices off the log so it's like a disc or are you ripping through the log so it's side grain wood. The drying with either one is quite a bit different. Thickness also makes a huge difference. If it's 1" thick and slice of the trunk it may be getting close to dry depending on where you live. If it's 2" thick and ripped it's not even close to dry.

It is the wood movement from further drying that is leaving a lump near your patches.

Tell us where you live, how the wood is cut, thickness, and species and we can help you better.

Re: sealing cracks in wood

#5

Re: sealing cracks in wood

TomD

I don't think the material is the likely cause, though I always use epoxy, and have some filled spots that are 25 years on. No problem.

I made one table, 5 boards, about 1.3" thick. The joints were all invisible. But some years on, one of the joints feels like I glued it up, but never levelled it. It is just creep along the joint. Stuff will move around as it settles in.