Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Refinishing question/ Water mark....

Posts

Refinishing question/ Water mark....

#1

Refinishing question/ Water mark....

Barry Irby

The walnut table I mentioned in the post below has a water mark on it. Center of the top about eight inches in diameter. The finish may be some sort of varnish and is very tiny. Who ever finished it did not fill the grain. Been a long time since I refinished anything. Whats the approach? How do I determine what the finish is? Or do I just sand it off and refinish it? The water mark does not appear to be deep. Did not blacken the wood, just ruined the finish.

Re: Refinishing question/ Water mark....

#2

Re: Refinishing question/ Water mark....

JMOHNIKE

Quick test. Apply a little fingernail polish remover on the tip of your finger gently rub one area of the water mark. It may remove it or lessen the amount of disscoloration to where it is acceptable. You can do this several times, but just a small amount on your finger, do not apply the remover directly to the finish. This will work with lacquer and some other finishes. If this does not work strip an refinish. Good luck.

Re: Refinishing question/ Water mark....

#3

Re: Refinishing question/ Water mark....

TomD

If you have some chemical finish left over from the 50s, I wouldn't be so sure. But for traditional finishes of oil or shellac, you can sometimes lift it with alcohol. In theory the moisture is still in there, that is why it is marked.