Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Spraying Polyurethane

Posts

Spraying Polyurethane

#1

Spraying Polyurethane

Butch...Mn

Is it possible to spray water based polyurethane with a gun that I normally use for auto top coat finishes? I put together a large cabinet for my farm shop and hate to think of brushing poly on the cabinet and all of the shelves.

Re: Spraying Polyurethane

#2

Re: Spraying Polyurethane

Bill Tindall, E.Tn.

Thin 3:1 varnish to mineral spirits and the solvent based stuff sprays just fine. Pick a warm day or the drying may be extended.

Re: Spraying Polyurethane

#3

Jason Roehl in Lafayette, IN

The tough part...

Jason Roehl in Lafayette, IN

...will be spraying inside the box. If it's quite large, and the shelves are removable, then it's not too bad to spray, but you can end up with lots of "fog" that settles as dust inside the cabinet.

An automotive gun might do it, maybe some thinning would be necessary, up to 5-10% tops.

A compromise would be to use a short-hair paint pad--they work very, very well with waterborne poly on large surfaces, and are pretty quick to boot.

Jason

Re: Spraying Polyurethane

#4

Jim DeLaney, Austintown, Ohio

Re: Spraying Polyurethane

Jim DeLaney, Austintown, Ohio

I've sprayed it with an HVLP gun, 1.5mm cap & needle, and about 12 psi at the tip. I sprayed it straight from the can - not thinned.

That said, I prefer to spray WB lacquer (General Finished "Enduro" or Target "EM6000") instead of poly. Easier to spray, and it 'burns in' to previous coats, making repairs later easier to do.

For greater durability than either poly or lacquer, I use ML Campbell "Agualente" Pre-Cat lacquer.

The lacquers all work well thru a 1.2mm cap at about 10~12 psi.