Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Pen turning

Posts

Pen turning

#1

Pen turning

Doug Ridley

I'm looking for info on turning pens. I have a Delta lathe 36" bwt centers and have done a little turning over the years on such things as chair spindles, etc. but I am by no means an accomplished turner. What I need to know is do I need a bunch of special odds and ends to fit onto my lathe . Also do I need to purchase pen blanks or is it feasable to cut them out and drill them from scratch. Not even sure I know the right questions so chime in with any advice you think might get me started in the right direction.

Re: Pen turning

#2

Re: Pen turning

Bill Tindall, E.Tn.

you can cut pen blanks out of anything- wood, bushes, deer antlers, plastic, there seems to no end what a friend makes them from. They are trivial to turn, actually boring. Zero challenge. When I make some, for gifts etc. my friend brings over his stuff that is needed- mandrel for holding the blank, barrel insertion tool, etc. No doubt some turning supply catalog has all this stuff listed.

Now if you want a challenge and a sharp result go to Nick Cook's web site and see how to turn the plastic part of a Pental P217 drafting pencil into a wooden pencil.

Re: Pen turning

#3

Re: Pen turning

Ken Romines

Doug

You might repost your question on the turning board (click the messageboards in the upper left corner). There are guys there that have forgotten more than I know about turning. Also, you might check the marketplace (on the same marque) for Rockler or Packard for pen turning information. And yes, you will want more tools to turn with, its addictive. I use a 12x36 Delta to turn some pens with, also have a smaller lathe that I travel with some.

Enjoy the addiction, its fun.

Ken

Re: Pen turning

#4

Re: Pen turning

Scott Greaves

Hi Doug!

Pen turning is fun! You'll enjoy it.

There are a few things you'll need to pick up, but it isn't too bad. And yes you can cut your own pen blanks! Out of almost anything.

Check out "turning between centers" over at the IAP (www.penturners.org). Good luck! And please report later on your success.

Scott.

Re: Pen turning

#5

David Barnett

(Message Deleted by Poster)


Re: Pen turning

#6

Can't hardly find a better supplier

Dick Coers

than Ed Brown either. He and his wife Dawn run a great business in Racine, Wi. Where you located? I set up a pen turners gathering at Bloomington, IL on April 26-27, and there is another on on May 17,18 in Glen Allen, Va. The IL event will be it's 7th year, 1st for Va. You'll learn everything there is to pen turning, and be able to visit with suppliers.

Re: Pen turning

#7

Re: Pen turning

Don Orr

There are a ton of books availble from multiple suppliers such as Amazon, Craft Supplies, Packard Woodworks, etc. You can get a free DVD on pen turning from Penn State Industies. Lots of youtube videos too.

Stop in over on the Turning side of this forum and you'll likely get more info than you can imagine.

Re: Pen turning

#8

Re: Pen turning

Doug Ridley

Thanks everyone. I thought I had posted this on the turning site but as normal I was wrong. I'll move it now.

Re: Pen turning

#9

Re: Can't hardly find a better supplier

Doug Ridley

Im located in Paducah,KY but don't travel much any more so I'll stumble along here as best I can. Thanks for the invite though.