Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Drawer sides and well

Posts

Drawer sides and well

#1

Drawer sides and well

Dustmaker Mike

So today I got some shop time in and I am trying to practice making drawers and face framing. Things are going great up until I go to put the drawers together. Seems I forgot to flip around one of the side on each of the drawers so now I have all lefts and no right hand sides. Well I am glad I am only practicing cause if I had to go buy a new piece of wood for a stupid mistake I might not be laughing.

Re: Drawer sides and well

#2

Re: Drawer sides and well

John Luke

Two lefts do not make a right.

(Been there, done that)

Re: Drawer sides and well

#3

As An Aside, Mike

George Colonel's Workshop-Havertown PA

:D Good Evening Mike,

The whole exercise could turn into a route. Right?

George

Re: Drawer sides and well

#4

Re: Drawer sides and well

don stephan

Very easy to do this. I try to mark the outside top front of each drawer side and make sure mark coordinates with those on drawer front and back as I'm laying out and sawing/chopping dovetails.

Re: Drawer sides and well

#5

Re: Drawer sides and well

David Hay Denver

Since you're practicing anyway, you might practice recovering from the error. I assume the problem is that the groove for the drawer bottom is on the wrong side? If so, one way to fix the part is to rip off the bottom of the drawer side even with the top of the groove. Then, find a piece that matches the grain pretty closely and glue a new piece on. Cut the drawer bottom groove on the correct side and recut any dovetails or whatnot to complete the joiner to the front/back.

Re: Drawer sides and well

#6

Re: Drawer sides and well

Dustmaker Mike

hum sounds like a good plan. I have already remade the sides but I might just play with one of them and have three drawers.

Re: Drawer sides and well

#7

Re: Drawer sides and well

Henry Ruehle

A fix might be to flip the drawer side so error dado or rabbet now is inside the drawer with error groove at the inside top, then just cut new dado for the drawer bottom at the inside bottom and fill error dado at the top with strip of wood. Fill any end with wood strips if needed.