Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Can I use These ?

Posts

Can I use These ?

#1

Can I use These ?

Lester Gillett

I received 3 real nice tools from my SS, Thanks SS. What i would like to know is could i use

the two chisels for wood turning tools ? the flat one I would like to use a bedan tool on the lathe. The other one I will just use for a wood chisel if not good to use as a turning tool.

Marry Christmas and happy New Year to all Woodcentral Folks.

Lester


img

Re: Can I use These ?

#2

Re: Can I use These ?

Bill Houghton, Sebastopol, CA

I did my first woodturning with a 3/4" wood chisel, held bevel side down and manipulated very carefully - basically a scraping cut. I read a story by someone whose first woodturning tool was a screwdriver ground to a sharp edge. I'd be careful not to catch the tools - you're lacking the leverage the longer handles of wood turning tools give you. But, sure, give it a shot.

Re: Can I use These ?

#3

the probelm

Bill Tindall, E.Tn.

These will be carbon steel chisels and they may be more or less abrasion resistant, probably less. Hence, expect the mortise chisel to not hold up as a bedan like you are used to with a typical modern lathe tool. It would be a better idea to regift to someone that does hand tool work as that seems to be a fine mortise chisel and gouge that would be useful to a hand tool person.

You can make a bedan from a metal lathe tool bit. With a bit of searching you can find already heat treated M2 lathe bits that are half inch by six or eight inches.

Re: Can I use These ?

#4

Ellis Walentine

I wouldn't

Ellis Walentine

As Bill said, the steel isn't optimal for the high heat of turning. It will dull relatively quickly. That said, if you really wanted to, you could use them, but only for very small work. The tang on the carving chisel in particular is not sturdy enough to chance it breaking under the pressure or shock of heavy turning, so there is a real safety concern, too.

I'd keep them for their intended tasks and make or buy the lathe tools you want.

Ellis

Re: Can I use These ?

#5

Re: I wouldn't

Lester Gillett

Thanks guys. I didn't think about the steel beaning able to use in turning. So i will just use them

as is and buy some turning tools for what i need. Marry Christmas to all.

Lester