Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Need assistance designing a "desk"

Posts

Need assistance designing a "desk"

#1

Need assistance designing a "desk"

AZ in Colorado Springs

A friend has asked if I can build him a desk that can be configured either as a "normal" desk (actually more like a small table) for use while seated, and can be converted to a standing desk.

This piece of furniture would have no drawers, and can have no apron or stretchers across the back, as the back is desired to be open when used as a standing desk (in this description, the "back" is the side where the user is seated or standing, and the front would be the side where others approach from).

The length and width would be 36"x24", and the height either 29" or 43".

I've seen no plans available for such a desk.

I'm thinking frame and panel construction for the sides and front, probably dovetailed where the front and sides meet, along with some angular braces to provide rigidity. The top (itself probably a fame and panel assembly) would rest on the top edges of the sides and front, registered using dowels or larger tenons. To elevate the top 14", three separate panels would be positioned between the base and the top along the front and both sides, the top laid down again, registered in the same way with dowels or tenons.

But how to ensure the whole structure is sturdy enough for for regular use and survives several moves in a military career? Suggestions?

Thanks

Andy

Re: Need assistance designing a "desk"

#2

Re: Need assistance designing a "desk" *LINK*

William Duffield

You might want to consider using Geoff Noden's Adjust-a-Bench for the structure and height adjustment mechanism. Once you have that, the working surfaces, aesthetics, etc., should fall into place. This thing is built like a Hum-V.


Adjust-a-Bench

Re: Need assistance designing a "desk"

#3

Re: Need assistance designing a "desk"

Jesse Cloud

How about this: a slab of wood hangs from the ceiling, suspended by wires connected to each corner of the slab. Under the slab are two sets of folding legs, one for sitting height, the other for standing.

Ideally, there would be some simple mechanism to hoist and lower the table evenly.

Re: Need assistance designing a "desk"

#4

Re: Need assistance designing a "desk"

charlie belden

How about a sash window idea - with underside drawer guides?


If the "front" (away from the person sitting or standing at the desk) were filled in for more rigidity?

Re: Need assistance designing a "desk"

#5

Re: Need assistance designing a "desk"

Jerry Gibbs

I envision hollow legs either round or square. They would have inner posts that could be raised or lowered. The posts could be secured with pins or screw knobs. The top would be hinged at each post to accommodate the changing angle. Jerry

Re: Need assistance designing a "desk"

#6

What a three-layer top

Howard in Toronto

Design it for the correct height when it's being used in a sitting position.

When it's needed as a standing desk, unfold the middle layer so it's vertical. Have the third slope down toward the first element like an antique mobile writing desk.

Easier to unpack when needed as a sitting desk.

My 2C.

Howard