Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Oval picture frame help

Posts

Oval picture frame help

#1

Oval picture frame help

Robert Hayward

I am going to cut an oval picture frame out of the frame in the picture. the width of the oval frame will be 7/8" wide. How should I make the four joints ? Just butt glue them ? If I should use a spline of some such how do I get it in that tiny of a space without it showing in the final frame ?

The frame will be rabbeted for the 1/4" thick wood picture and the face of the oval will be shaped with a router.

Bob


img

Re: Oval picture frame help

#2

Ellis Walentine

Couple options

Ellis Walentine

If you have a Domino joiner or a horizontal mortising machine, you could ideally cut loose tenons into the exact places where the frame will be. Biscuits are a simpler way. If the biscuit joiner cuts are visible, they would have to be plugged or filled.

Ellis

Re: Oval picture frame help

#3

Re: Oval picture frame help

Keith Newton

If you make the splines from the same kind of wood, is it really a big deal that they not show?

I think I would like seeing that. Why make life harder than it needs to be?

Re: Oval picture frame help

#4

Re: Oval picture frame help

doug f, san clemente, ca

Or you could make the splines from a contrasting wood and highlight them as a "design feature."

Re: Oval picture frame help

#5

Why not a single dowel at each joint?


Re: Oval picture frame help

#6

Re: Oval picture frame help

Yonak

Bob, how about lap joints or, similarly, fairly thin but broad inset connecting pieces on the back side ? They may even be attached with strategically placed screws or pins and would be the same wood and coordinated grain direction as the frame pieces with no spaces, as may be with a spline.

Re: Oval picture frame help

#7

Or locate the splines inside the rabbet


Re: Oval picture frame help

#8

Re: Oval picture frame help

JMOHNIKE

Nothing wrong with a T&G joint. Has worked for me on many frames.

Re: Oval picture frame help

#9

spline of identical wood

Bill Tindall

The spline must align with the rabbit so that it does not show in inside. It will show on outside, but not much

Re: Oval picture frame help

#10

Re: Oval picture frame help

Robert Hayward

Thanks everyone, a bunch of good ideas. I am working in a modest garage shop and do not have machines like a horizontal mortiser.

T&G and lap joints, why did I not think of these joints ??? Easy to make and strong enough. I was too hung up on figuring out a way to hide a spline. Why hide it ? Like I just said, in my mind the spline had to be invisible.

I have already cut the wood to length so a lap or T&G will have to be considered for the next oval frame. A spline hidden by the rabbet inside and exposed on the outside sounds good to me this evening. Matching or contrasting ? Probably contrasting, maybe using some of the maple from the sky in the picture.

Bob


img

Re: Oval picture frame help

#11

Ellis Walentine

Coming together nicely

Ellis Walentine

Nice veneer work there, and splines are a fine way to handle it.

Ellis

Re: Oval picture frame help

#12

Re: Coming together nicely

Robert Hayward

Thanks for the kind words. It is not veneer work though. Rather double bevel inlay done on a scroll saw.

Bob