Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

PM2000 Dust Collection?

Posts

PM2000 Dust Collection?

#1

PM2000 Dust Collection?

Derek Arita

I'm wondering how good the dust collection setup works in the PM2000? I know that a lot depends on the suction provided, but aside from that, is the routing of the dust, effective?

Re: PM2000 Dust Collection?

#2

PM 66

Merle

Derek,

I have a PM 66 that does not have the 4" flex tubing going up to the blade so I can't give you any first hand experience. However, I imagine that feature makes a world of difference for the dust that stays below the table and may reduce the dust that comes off the top of the blade.

I also need a collector for the dust that comes off the top of the blade and use a SharkGuard for this.

HTH,

Merle

Re: PM2000 Dust Collection?

#3

What I did:

DizD

I've had PM2000 for about 6 years. Several years ago I removed the interior hose, but not the blade shroud ( the hose is 3" dia. and I didn't like it necked down like that.) Then I cleaned and waxed the bottom of the saw cabinet and I have been using it like that. Still have to clean out cavity several times a year, mainly because of small strips that get caught around the opening. Dust collection does not seem to be any different without the hose.

Re: PM2000 Dust Collection?

#4

Re: What I did:

Derek Arita

Why is that 3" not a 4"?

Re: PM2000 Dust Collection?

#5

Re: What I did:

DizD

Don't know. What I understand about dust collectors is that they need large air volume to work correctly. The 4" outlet at the base reduced to 3" inside didn't make sense to me.

Re: PM2000 Dust Collection?

#6

Re: What I did:

Derek Arita

Has anyone here run 4" all the way to the internal shroud?