Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Larvae (or something) in the ash

Posts

Larvae (or something) in the ash

#1

JL

Larvae (or something) in the ash

JL

Started prepping some ash for a project yesterday. I saw some small holes (1/16"-3/32" in diameter) in the surface.

I was able to clean up the 8/4 ash okay. The tunnels hadn't gone far enough into the wood and I was planing it down to 1 1/2". The 5/4 ash looks to be a loss. The tunnels start at the surface and then burrow down along the grain lines. I might be able to salvage enough to be 1/2" or 5/8".

I did see a little frass around the tunnel openings. As I planed down, I saw some yellowish larvae (worms or whatever). They got dosed with lacquer thinner and the board was set outside.

I didn't see any insects - just larvae. I haven't seen any flying insects in the garage where I store my wood. Only ash showed holes. I've inspected the rest of my ash lumber for holes and I've planed down all that had holes.

Possible powder post beetles or what?

Re: Larvae (or something) in the ash

#2

Re: Larvae (or something) in the ash

Keith Newton

JL, When you find the little round holes on the surface, those are normally the exit holes of the adult beetle, leaving to go find a mate. After mating, the females lay their eggs in tiny checks or pores, where they start the next cycle. Those are probably too small to see naked-eyed.

The surest way to get rid of the insects, and their eggs, is with heat.

Re: Larvae (or something) in the ash

#3

Dale Lenz

Re: Larvae (or something) in the ash

Dale Lenz

If my memory serves me correctly, PPB larva follows the grain, Ambrosia goes across grain. PPB loves ash and pecan wood. My recommendation is to make firewood out of the ash lumber, sorry. Keith is correct heat is the "insecticide" at this stage of the game, something like 135°F at the center of the board for a few hours. Guess it depends on what I'm making: A wooden jig I'd probably use it, for a customer, I'd heat the shop with it. Your problem is exactly why I wish to purchase my lumber the same day the tree was dropped and take control of the drying process from there.

I have a few PPB mounts that an entomologist gave me, they are pretty small and as I understand they are nocturnal critters. So...seeing the adult's PPB flying around in your shop is not a very good option.

Re: Larvae (or something) in the ash

#4

Re: Larvae (or something) in the ash

Bill Tindall

Ash is the most susceptible wood to these boring critters in my experience. I treat any ash that will be stored with insecticide and it works to prevent the damage. For an ongoing infestation the lacquer thinner is a good plan. The vapors of the ester solvents are especially toxic to bugs.

I have always wondered whether bagging a board with moth balls would work. I would expect it to.

Since you can see larva you have the opportunity to try various treatments to see what will kill the larva within the board. Let us know.

Re: Larvae (or something) in the ash

#5

Re: Larvae (or something) in the ash

John Veerkamp

Moth balls in a plastic bag with the wood kills mesquite worm/larva, should work foe PPB.

Re: Larvae (or something) in the ash

#6

thanks for info

Bill Tindall

always thought it should work