Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

OT- Snowblower Skids

Posts

OT- Snowblower Skids

#1

OT- Snowblower Skids

tom

Has anyone made skids for their snowblower out of wood? I sealed my drive and donot want to "scratch" the coating all up.

Thanks!

Re: OT- Snowblower Skids

#2

Buy some cheap skis at a garage sale

Merle

I haven't done it, but if you cut them to the proper length and wax them well, it seems like they would hold up okay if you avoid bare pavement as much as possible.

Re: OT- Snowblower Skids

#3

Re: OT- Snowblower Skids *LINK*

Bill Howatt

I had a sidewalk installed made of the concrete pavers and I also had the same concern.

I made my skids out of UHMW plastic and it worked very well. They have now worn down a bit so I'd better check them but they have lasted more than 5 years so far.

http://www.leevalley.com/en/hardware/page.aspx?p=32045&cat=3,43576,32045

I'm not 100% sure I used LV the UHMW or some I got elsewhere.

I haven't tried wood.

Bill


LV UHMW Plastic

Re: OT- Snowblower Skids

#4

Re: OT- Snowblower Skids

tom

UHNM! Thanks I have some kicking around the basement. Tomorrow I will look at making something up.

Re: OT- Snowblower Skids

#5

Re: OT- Snowblower Skids

Lee Schierer McKean, PA

I took some strips of UHMW sand attached them to the existing steel skids on my snow blower, because the concrete driveway was wearing away the steel too fast and new skids were pricey. I made several sets that wrap around the bottom portion of the skid and attached them to the skids with screws. So far, I'm still on my first set after 3 years.

Lee