Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

OT - anybody know Larry the Cable Guy?

Posts

OT - anybody know Larry the Cable Guy?

#1

OT - anybody know Larry the Cable Guy?

Joe in a Cleveland suburb

Does anybody know how the cable signal works for cable tv?

The cable from the cable company goes from the pole to my house where it goes into a box on the side of the house.

From that box (that contains a splitter) one cable goes on the outside of the house up to a bedroom where there is a jack.

The other cable goes from the box into my basement. In the basement, maybe 15 feet from the box/splitter outside, is another (cable company supplied) splitter.

This splitter goes from one to two. One cable goes to the kitchen tv, and the other cable goes to a splitter I put in many years ago.

Its all worked fine until the other day. I decided to run a cable from my splitter (bought at Radio Shack a long time ago) into my sunroom directly above the splitter. I used a 12' cable purchased from Lowes.

I pulled it up through a hole I drilled in the floor behind the base board to the tv. Hooked up the tv and no signal. I tried a couple different tv's - hook up the

cable, use the scan option on the tv, and get nothing. Tried the same tv's at different cable locations, works fine.

I thought maybe the cable was bad. Tried several different cables. No luck. Thought the splitter went bad, bought a new one, no luck. What the heck

is going on? Tried different ports on the splitter(s). No luck.

Is there any way to test the signal or something without the fancy testers the cable guys use? It's as if this sunroom has some super power not allowing

cable signal into it.

My tv, phone, and Internet all work off this cable.

I might just have to give in and call the cable guy...

Thanks for any suggestions!

Re: OT - anybody know Larry the Cable Guy?

#2

My only thought...

John in NM

Is that there's getting to be an awful lot of splitters in your set up. You loose signal strength with every split, and unless there is a booster in the system somewhere, you will eventually fall below the tv's detection threshold. It was all a little easier before digital signals and scan functions - you could tell the signal was too low because it looked awful on the screen :D

Re: OT - anybody know Larry the Cable Guy?

#3

You split it to much

Dustmaker Mike

Every time you split a signal it halves it so after three split you pretty much have no signal left. So to fix it go to the first splitter in the house and get another one that has an extra port on it so you can connect to it with the new TV. Okie Dokie

Re: OT - anybody know Larry the Cable Guy?

#4

Jason Roehl in Lafayette, IN

Agree with the others...

Jason Roehl in Lafayette, IN

I'm a die-hard DIYer, and also a contractor (mostly painting). On the occasions I'm around other tradespeople, I can't help but pick their brains a bit on how to do various things related to their specialty--maybe ways to do it better, faster, or even about something I have no clue how to do.

All the cable guys I've talked to have told me the same thing--one splitter and one splitter only. If you have 5 things hooked up to cable (phone, cable modem, and 3 TVs), then you need a 5-way splitter and a line from that splitter to each of the devices. Don't go cheap on the splitters, either.

Also, try asking your cable company for the needed cables, connectors and splitters. Mine has told me before that they prefer giving away cables because it's a LOT cheaper than a service call due to cheap cable.

Jason

Re: OT - anybody know Larry the Cable Guy?

#5

Re: OT - anybody know Larry the Cable Guy?

Alan in Little Washington (NC)

I'm not sure I followed you wiring, but is there a TV on the other tap coming from the splitter and does it work? Are you sure signal is getting to the splitter? Take the TV to the basement, remove the splitter and connect the TV directly to the cable feeding the splitter.

Even with the excessive numbers of splitters you should be able to get some signal, but remember, unlike analog where you will see weak signals, with digital, you either have signal or you don't.

Re: OT - anybody know Larry the Cable Guy?

#6

Re: OT - anybody know Larry the Cable Guy?

Monomoy

Joe:

The signals that some of the cable companies send out now require a descrambler (cable box) in order for the TVs to work. Some of the cable companies provide them free of charge for just basic reception.

Monomoy

Re: OT - anybody know Larry the Cable Guy?

#7

Re: OT - anybody know Larry the Cable Guy?

Doug in Utah

Are you using cable marked RG6U 75 ohm? Not sure if that could be the problem or not.

Re: OT - anybody know Larry the Cable Guy?

#8

Larry came over last night...

Joe in a Cleveland suburb

Hi guys. Thanks for all the advice. You were all basically right.

I had the cable company come over. He replaced the junk Radio Shack splitter, replaced a junk Lowes cable or two, replaced a couple cable ends, and added an amplifier. It all works now.

Some jobs just aren't worth doing yourself...

Thank you.