Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

OT Wiring a heater

Posts

OT Wiring a heater

#1

OT Wiring a heater

Dustmaker Mike

I was wiring the heater in my shop this weekend to the thermostat and I have a question. I have a battery operated thermostat and it does not have a "C" connector which I think is common for the 24V AC it does have the "R" "G" "W"connectors. The heater is a Mr Heater 45000 BTU shop heater. It has a "C" connector along with a "R" "G" and a "W" connectors. I did not hook up the "C" connector on the heater, I did hook up the "R" to "R" etc so did I do this right? I am pretty sure I did but something in the back of my mind is saying check and then double check this.

Thanks

Re: OT Wiring a heater

#2

Have you contacted the company?  They should know.


Re: OT Wiring a heater

#3

Re: OT Wiring a heater

Galen Vetterick

I would think your heater and thermostat would both have good wiring diagrams. Strange not too!

R on heater, one side of control power, normally goes to R on thermostat

G on heater to G on thermostat to allow manual blower control

W on heater to W on thermosat, this is call for heat

C on the heater (grounded power) to C on thermostat and thermostat GND hooks to C as well for programable thermostats

This is what I remember so again should be checked to your actual components.

Re: OT Wiring a heater

#4

Re: OT Wiring a heater

Dustmaker Mike

Thanks that is what I did. This is a battery operated Thermostat and both the heater and thermostat had the instructions and I looked at them and almost understood them. I was just checking to see if I messed up with the common or C connector. It looks like I didn't now to hook up the NG and away I go with heat in the shop.