Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Spray Gun Advice

Posts

Spray Gun Advice

#1

Spray Gun Advice

Barry

I have a new HVLP spray gun that I bought at Woodcraft. It sprays much better than the Harbor Freight model I’ve been using, but when I spray with it, the surface is a bit rough, almost orange peel-like.

Yesterday, I was spraying Sherwin-Williams sanding sealer, thinned about 30 to 40 percent. I warmed the shop up to 72 degrees starting about 7 AM and took the can of sealer into the house to warm it up. I’m spraying at 30 lbs at the regulator on the compressor, with a 50 foot, 1/4 inch hose. I know I’m losing pressure through the hose, but don’t know how much. I have hesitated to just crank up the pressure, because it is an HVLP gun. Do you think I just need to crank up the pressure a bit? Or get a shorter/larger hose? Or, get a regulator for the spray gun? Or, all of the above? Thanks.

Re: Spray Gun Advice

#2

Re: Spray Gun Advice

Richard McComas

http://www.finishwiz.com/orangepeel.htm

Re: Spray Gun Advice

#3

my 2 cents

Merle

Barry,

I think a regulator at the gun is critical so you know where the pressure is. I keep my gun at 8psi with the trigger pulled. I would try spraying a little more fluid on a sample piece and/or reducing the fan size to see if that goes any better for you. Finally, what is the humidity level in your shop? HTH

Merle

Re: Spray Gun Advice

#4

Re: Spray Gun Advice

del schisler

i wouldn't increase the air i would leve at 30lbs, that is what mine is set for , i have a 25 foot hose, i don't belive you are loosing that much preasure, i use a 2 mm nozzel and i don't thin that much maybe 10 percent, i use M.L.CAMPBELL sanding sealer and than the top coat's, this company is owned by sherman william's , but M.L. they make their own lacquer, i belive thinning that much may be to much, and do you spray away from you ? and not from the end toward's you ? You may have found out this all ready , i live in central florida 10 miles from the ocean. If the hummity is to high all you will get is a milkey look with the sanding sealer, i don't worry about that i just wait tell it dry's and sand and than shoot it with the top coat, the milky look will disapear, good luck i have a preasure gage on the compreasure and a filter on the comp. and one on the gun a little one just as a back up for moister.

Re: Spray Gun Advice

#5

Re: Spray Gun Advice

Barry

Thanks for the spray gun advice. I changed several things before starting this morninig. I switched to a 15 foot, 3/8" diameter air hose. I opened the air adjustment on the gun all the way. I thinnned the lacquer a bit more. I am able to lay down nice, wet coats now and am getting much better results now.