Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Sick Rockwell 6 x 18" 22-201 surface planer

Posts

Sick Rockwell 6 x 18" 22-201 surface planer

#1

Sick Rockwell 6 x 18"   22-201 surface planer

Pete in Holland, MI

Guys -

While planing some boards on my early 70's vintage 22-201 Rockwell planer, some growling from the feed roll mechanism resulted in loss of feed roll operation.

An autopsy into the machine yielded a worm gear from the feed roll gear box with no teeth left.

I did some reasearch and found Rockwell / Delta does not handle that gear any more. More research found an aftermarket builder of the gear, worm, and bearing rebuild kit for the whole planer for $629. Another site yielded only the gear and worm for about $500.

Are there any other places to find a new gear at a lesser price, either new or used ? I'm not ready to drop this kind of money in this ole machine.

Thanks for advance in your help !

Pete

Re: Sick Rockwell 6 x 18" 22-201 surface planer

#2

You need OWWM *LINK*

Bill Houghton, Sebastopol, CA

or Old Woodworking Machines, a site that focuses on just what it sounds like (threshold is 25 years old or older). Link below. Ask the question on the OWWM forum, and post a want to buy on the buy/sell forum (BOYD, Bring Out Your Dead - the originator of the site's clearly a Monty Python fan).


http://owwm.org

Re: Sick Rockwell 6 x 18" 22-201 surface planer

#3

Take some measurements... *LINK*

John in NM

Diameters, bores, pitch. You may be able to fudge a bit on the pitch, but the diameters and bore sizes will probably have to be exact.

One place to look is McMaster Carr


McMaster Carr

Re: Sick Rockwell 6 x 18" 22-201 surface planer

#4

Re: Sick Rockwell 6 x 18"   22-201 surface planer

Robert Lemon

try Rush Gears Inc. http://www.powertransmission.com/copage/549_Rush-Gears-Inc/

Re: Sick Rockwell 6 x 18" 22-201 surface planer

#5

Rick L

Re: Other thoughts...

Rick L

I have the same planer and it's a great machine es[ecially on curly woods with the low feed rate. I changed the worm gears 20 years when Delta still had them. Running out of gear oil is the cause. I've always thought if it happened again I was going to adapt a gear box in place of the worm gears but I'm diligent about keeping the gear oil level up. www.surpluscenter.com is a good source of cheap gear boxes. You'll have to calculate the ratio from the worm gears to find a suitable match.

You have the links to those worm gear source you mentioned? Just curious to check them out.