Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Finally got the TS back to normal...

Posts

Finally got the TS back to normal...

#1

Finally got the TS back to normal...

John in NM

Some may remember the old repulsion induction motor on my unisaw quit maybe 6 months ago. Installing a new 3HP Leeson was straight forward, but since it runs faster than the old RI motor I needed to replace the motor pulley and belts as well. Vendor I ordered them from at the time was out of stock, due to Delta changing hands - so the vendor said.

So I've been running it at 5,000 + rpm and a cheap blade from HD that says its rated to 7,500 rpm... cut was rough, but it sure melted right through anything you threw at it :D

Tried ordering a pulley and belts again, different vendor, before resorting to the high price of a Grainger stocked pulley. Got the replacements last week and installed them, cut is back to the super smooth that I remember from this saw with any decent premium blade on it :D

Well worth it, and one of those "why did I wait so long" sort of fixes. Now I just need the new bearing for my old Hitachi slider, and I'll be back in biz...

Re: Finally got the TS back to normal...

#2

Ellis Walentine

Glad to hear it, John

Ellis Walentine

5,000 rpm is about 60% too fast, although most blades are tensioned to work properly up to about 8,000 rpm. Still, that's a lot of momentum at those speeds.

Ellis

Re: Finally got the TS back to normal...

#3

Re: Finally got the TS back to normal...

Jason Waters

I'm glad you got it fixed. I can't believe the pulleys used to be different.