Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Emmert vise info request

Posts

Emmert vise info request

#1

Emmert vise info request

Gary Smyth

I have had for a couple of years a Emmert patternmaker’s vise. I believe that it is a number 2, 14 inch. It was a very nice find, but it does not have the tilt under table bracket stand or the tilt bar. I believe the numbers are K-44 assembly including a K-44 bench bracket, cam locking lever (K-64), eye bolt (K-4), and lock nut (K-72). Yesterday I found a Emmert turtle vise with serious problems, but it has a tilt assemply without damage. Will the turtle tilt fit the No.2? Update—there is on ebay a tilt bracket and the description says that they will work but so far no response from the ebay seller and besides, I’m looking for a second confirmation. Can anyone directly help or send me to a source for the information?

Re: Emmert vise info request

#2

Re: Emmert vise info request *LINK*

Bob Entwisle in NJ

Hi Gary,

Sorry I've no experience with the Emmert, and you probably already have this link, but I figured I'd post it just in case.

Hope it helps.

Bob in NJ


http://www.mprime.com/Emmert/index.htm

Re: Emmert vise info request

#3

Re: Emmert vise info request

Phil Smith

Contact Bill Kerfot at CS Machinery for repair parts for pattern maker vises. Bill makes new vises along with replacement parts for emerett vises..

Here is link to Bills site.

http://www.csmachinery.us/

Re: Emmert vise info request

#4

Thanks guys both sites have been emailed.