Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Managing big glue ups

Posts

Managing big glue ups

#1

Managing big glue ups

Stephen Kirk

Finally, the first bookshelf carcass is together. Everything went well. We did a full dry run and made sure we could assemble everything, clamp and close the joints within the glues working time.


I assembled the sides ahead of time. Still, getting the dividers and panels onto the back was a bit tricky. Practicing something like this is a definite must, because you don't want to have glue setting up and discover that a joint wont close. BTW, the lower front rail is dovetailed in, so there's no need to clamp there.

I know my front opening is square (corner to corner measurements were good), but I'm not sure how to determine if the whole case is square. I know the legs might have picked up some slight bow, so putting a square around it isn't very definitive. I have two more to assemble, and if there's something I can do to check for overall squareness, I'm open to suggestions. If something is a bit off, I can always "adjust" the shelves slightly when I make them.

Now that one is together, I'm happy with the look of the carcass members and the panels. I find they contrast well together. Once the finish is applied, they should look very nice. I pre-colored all the carcass pieces, and the panels will stay natural. The color is a bit darker in real life.

Re: Managing big glue ups

#2

Jason Roehl in Lafayette, IN

Re: Managing big glue ups

Jason Roehl in Lafayette, IN

Maybe make a slide stick. (Two sticks each with a long slot and pointy ends, with two bolts/wingnuts holding them together so that you can fix the assembly to a length). Then you could check the 4 diagonals inside the cases (in 3D, i.e., back-upper-left to lower-right-front).

Jason

Re: Managing big glue ups

#3

Re: Managing big glue ups

Stephen Kirk

You know, that's a great idea. I recall hearing about these, and now is the perfect time to make some. They'll be real handy on the next glue up. May as well make a few sizes while I'm at it. I could quickly check all the angles with a few of these.

Re: Managing big glue ups

#4

Re: Managing big glue ups

Dave Bair, Eaton Rapids, MI

What kind of glue did you use?

Re: Managing big glue ups

#5

Re: Managing big glue ups

Stephen Kirk

Titebond Original. I had plenty of working time, so didn't need any extended ones. Seems to be holding quite well.