Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

table saw fence

Posts

table saw fence

#1

table saw fence

Paul

I own an Atlas unisaw double belt driven off a large cast iron motor and am looking to replace the fence system since it always needs to be squared up front to back. The saw has a 1 1/2 inch cast iron top with bolt holes on the front 8 inches on center there are no bolt holes on the back of the table. I have measured a biesemeyer fence system and their holes do not match tne pattern on my table top. Any suggestions on a fence system that does not require a back rail and would bolt to the 8 inch pattern on the front would be appreciated.

Thanks

Paul

Re: table saw fence

#2

Re: table saw fence

Dale warder

One method would seem to be to drill the mounting rail from a Beismeyer type fence to match the saw table drilling. I have used this method to mount a Beismeyer fence on an old saw.

Dale

Re: table saw fence

#3

Bob

Re: table saw fence

Bob

Hello Paul, I have a biesemeyer and I do not use the back rail because it gets in the way of my outfeed table Here is what I did, I have a Shark guard splitter on order with over head DC. I use the tables to store panel sleds, Dado sets, push sticks, blades and miter fences.

Re: table saw fence

#4

Re: table saw fence

William Duffield

No problem at all with a Beisemeyer style fence and front rail from a number of manufacturers, including Delta, Powermatic, SawStop, Steel City (and probably Grizzly, although I have no personal experience with them). It is a simple matter of drilling holes in the appropriate places in either the rail or the saw top and wings (or both, as appropriate). The back rail in the Beisemeyer fence system is mainly to align the back of the table and wings and extension tables and to attach outfeed tables. It does not support the fence.

Re: table saw fence

#5

Re: table saw fence

Jason Waters

You can easily drill the front fence to fit. Some tables aren't plumb in the front, so you may have to shim the rail to get it perpendicular to the table surface.

As for you don't need the back rail, that's true for the Bisemeyer. But you have to have a table for the fence to sit on!!!! So if you don't use the back rail, you may not be able to put a table board to the right (or left) of your saw to allow the fence to cut full width. Unless you are building a table setup as shown, you really need a back rail to support the table board to the right (in my case).

The Bisemeyer is probably the easiest to adapt because of it's front only requirement. I love my Bisemeyer fence.