Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Finish for Rosewood????

Posts

Finish for Rosewood????

#1

Finish for Rosewood????

Barry Irby

My son built a keepsake box for my grand daughter, his niece. He is wondering what to use for a finish. Any experience/suggestions?

Re: Finish for Rosewood????

#2

Re: Finish for Rosewood????

Grant in Iowa

I have built a few small projects from Rosewood. On both, I simply sanded to 320 grit, then buffed the pieces on a buffing wheel with red rouge followed by a hand applied coat of wax. A long lasting high shine was the result, thanks to the oily and hard nature of the wood.

Some apply lacquer finish first, then buff the lacquer. I found Rosewood to be oily enough that it wasn't necessary. Lacquer first would likely contribute to a deeper looking finish, however.

If this is your first buffing project, practice on a piece of scrap first. Make sure you always work from the center of a surface towards and edge, and present the workpiece to the trailing or spinning way from you portion of the wheel.

FWIW,

Re: Finish for Rosewood????

#3

I've used oil...

John in NM

Either watco or tung oil. Scarcely needed, but they work fine. Keep the oil thin though and only a couple coats. Doesn't soak in the way we're used to with other woods.

Re: Finish for Rosewood????

#4

oops...

John in NM

meant to reply to Barry, sorry Grant :D