Cedar mailbox post,fasteners-23 yrs later *PICS*
Tim Greif - West of Chicago
Greetings folks, I haven't posted much lately. Some time back, there was a discussion about the types of posts that are best suited for direct burial for stuff like fences, mailboxes, decks, etc. I recently felt the need to replace my old cedar mailbox post that had begun to feel a bit loose in the ground. The piotures below clearly show why.
This is a cedar post direct buried in the soil that has been holding up my mailbox for 23 years. I jacked it out of the ground so I could keep it intact to show the degree of wood rot. I always heard that the most rot occurs in the first 8-14 inches down from the ground surface due to oxygen penetration. The picture verified that. The picture also shows the bottom to be pretty much ok, even though the bottom of the hole was visibly wet. I don't think the post would have stood another winter with snow from a plow being thrown against it.
The fasteners were a surprise too. Some of the deck screws were pretty much gone, while others seemed like they'd go another 20 years. Same with the nails. All fasteners were above ground, simply attaching the crossbar and diagonal brace.
Keep this is mind when you decide how to deal with your posts in the future. I would not want to have my deck column posts buried and wake up to this 20 years later. I decided to do the new post out of pressure treated timbers. Off I go to the local borg to pick up the straightest 4x4s I could find. Got them notched, cut and assembled and then set it in the garage, "just in case". You all know what happened. They proceeded to turn into a warped pretzel.
So I violated my own conclusion. Went back and got some select cedar posts and did the new mailbox with that. If I need to do this again in another 23 years, I can live with it. At least I buried the new post with crushed gravel this time.
Thanks for looking.





