Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

tool info needed

Posts

tool info needed

#1

tool info needed

grandy

https://picasaweb.google.com/115252728742818509638/20120912?authuser=0&authkey=Gv1sRgCIWFrP-osPnzQw&feat=directlink

does anyone know what this is for and what it's called. I purchased a shot and this

was with the forged hold-down so I though it may have something to do with the

workbench.

Thanks, Sandra

Re: tool info needed

#3

Re: tool info needed

Ralph Lipeles

It's for holding work to the workbench top. It is used with a bench that has a solid top and through holes for dogs. Position the work, insert the long section into one of the holes and tap it into place. When finished, tap it up from below and it will release and can easily be removed.

Ralph Lipeles

Re: tool info needed

#4

Re: tool info needed

grandy

the holder-downer-thingie I found at Woodcraft, but what

is the other thingie used for? Anybody know or is it something

not even suppose to be in the tool box.

Re: tool info needed

#5

Re: tool info needed

Henry Higginbotham

Hmmm . . . somehow I didn't see the sheet metal piece the first time around and misunderstood what you were asking. I still don't know what it is, but I'll be interested in knowing if it has something to do with woodworking.

Re: tool info needed

#6

It looks to me like a

Gary Smyth

portion of a power table saw hold down. Connected to the plate is a clear saw blade cover and the saw tooth anti-kickback fingers. That may be the support for a splitter. My impression is that it has nothing to do with the bench dog hold down. The thin plate I have that looks similar to what you show. Mine is an older JTS-10 Jet. The illustration shown here is also a Jet but not as close what you linked. The plate fitted to the saw blade insert opening.

Another possibility is it served as a bracket that attaches to the rear of the saw and protects people's fingers from the drive belt pulley

Re: tool info needed

#7

Re: It looks to me like a

grandy

Thanks Gary, Being a turner and small flatwork woodworker

I couldn't figure it out. I do know it's cast iron and very heavy.

Would like to find someone with a need for it, however, it would

be costly to ship due to weight.

Sandra