Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Dust Panel Hole Layout, Size and Quantity

Posts

Dust Panel Hole Layout, Size and Quantity

#1

Dust Panel Hole Layout, Size and Quantity

George Colonel's Workshop

Good Afternoon Friends,

I'm at the stage of making things again. To ease into "work", I decided to re-task my table saw right wing ito a sanding surface, repleate with under-table DC/Vacuum. It measures 27" X 15 1/4". My present right wing extension is a simple torsion box, which is glued shut. I have a used table top of particle board/plastic laminate which I can mount as a right table wing. I'll need to drill dust evacuation holes in it, and create a bottom to attach the suction device. I'll also need to keep the structure hollow for internal air/dust flow flow. Please comment.

George

Re: Dust Panel Hole Layout, Size and Quantity

#2

Re: Dust Panel Hole Layout, Size and Quantity

Bill Houghton, Sebastopol, CA

1. That project sounds like it'll really suck.

2. No dust on you, Colonel!

3. Why don't you just wing it?

4. I'm sure, when you're done, the hole thing will be quite impressive.

Re: Dust Panel Hole Layout, Size and Quantity

#3

JL

Re: Dust Panel Hole Layout, Size and Quantity

JL

Not too be as punny as Bill - but it depends on what size hole "liners" you happen to have.

The best set-up I've seen for a table had small plastic grommets or flanges that fit into the holes. They provided protection for the hole edge. They were also inset a bit into the surface so you could easily slide a board over them.

If you can find a source, that's the size I would drill the holes.

Re: Dust Panel Hole Layout, Size and Quantity

#4

Re: Dust Panel Hole Layout, Size and Quantity

Joseph Mulherin, sr

Hello, George, as JL mentioned, try going to say HD or Lowes and look at the brass gromment

holes protectors....and sink them just a little so they are flush with your table top. I would make the table top look a little like a pegboard...but not as many holes...just enough to get the dust cleared.