Re: Thanks for the feedback Dale.
Keith Newton
Dale, I sure wish he had found me before taking that tree down, because it would have been two boards, instead of 8. At least they were all uniform enough that they don't jump out at you.
I have a couple of saw horses, with a 3' x 7' door on it, with a full sheet of plywood on that, which has a 1" foam layer over that, which I stickered the wood on. Then I set up some legs to hold another 1" foam layer for the top, with a tarp over that hanging down all the way around about a foot below the bottom. I have a hole cut in one end, where I set a little space heater which oscillates, and is set on high.
The heater thermostat is never satisfied, since it is always pulling in outside air. I think it took three days to get the temp up to 165º with this much wood, then one more day. There was some sticky sap flowing in there. Some of those boards had a solid glaze, and after planing, they were translucent when we held a drop light behind some parts.
I stained it with Minwax Red Chestnut, mixed 1 - 1 with a clear stain base, and we soaked it with mineral spirits for a wash coat just before staining.
As you can imagine, sanding required some creativity. I was thinking initially that I would just hand plane all of the tops surfaces, and finish with an oil, or wipe on. But that edge-grain was roey, and I was getting tear-out, so I had Ben my helper fill a spray gun with water and a squirt of soap, then stand at one end of the stroke sander spraying the belt as it passed. That kept the belt from loading, without really getting the wood very wet.
From there, we took it outside in the shade, and sprayed mineral spirits ahead of the random orbit sander, to keep the disk from loading. Otherwise, a new disk would be clogged in about 15 seconds.
I think I went through 1.5 gallons of spirits on this desk. We were constantly cleaning knives and surfaces.




