Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Mackissic wood chipper question...

Posts

Mackissic wood chipper question...

#1

Mackissic wood chipper question...

David Sparks

This is probably a long shot, but does anyone know how to set the knife gap on a Mackissic Mighty Mac chipper? I have read online that the knife needs to adjusted with a gap of 1/16" to 1/32" by moving the wear plate. I don't know what gap they are referring to. There are no diagrams or photos online that I can find. I am going to try to get a manual from Mackissic this week, but it would be great if someone here can explain this to me. Thank you.

Re: Mackissic wood chipper question...

#2

Re: Mackissic wood chipper question...

andrew nistock

David, the gap that they are referring to is between the rotating knives and the stationary knife or wear plate. The wear plate will have to be loosened and moved to get the proper clearance. If you don't know where the wear plate is look inside the machine where the wood meets the rotating knives and you will see it. Be careful when working in this area as the knives could easily cause serious cuts. If the chipper is gas powered remove the spark plug from the engine before starting to work on the machine. If it accidentally starts you could loose a hand in a split second or worse. I don't own a chipper but have knowledge of this type of set up. Hope this helps and be CAREFUL. Andy

Re: Mackissic wood chipper question...

#3

Re: Mackissic wood chipper question...

David Sparks

Thank you for explaining that to me, Andy. I couldn't find the wear plate to save my life, but with your help I found it. I see how it works now. Now if I can just get the bolts loose on the chipping knives. Don't worry about me being safe. I am about scared of that beast! Thanks again for your help.

Re: Mackissic wood chipper question...

#4

Re: Mackissic wood chipper question...

andrew nistock

David. Check to be sure if you need to move the wear plate or the knives. Some systems have a fixed wear plate and some have a moveable wear plate. Andy

Re: Mackissic wood chipper question...

#5

Re: Mackissic wood chipper question...

David Sparks

The wear plate on my chipper is adjustable. The problem I'm having is getting the Allen bolts holding the knives loose. I need to get a torch hotter than my propane one, evidentally. The bolts are Loctited in and tight as can be. Thank you again for your help, Andy.