Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

retrofittng jointer fence

Posts

retrofittng jointer fence

#1

retrofittng jointer fence

Jerry Gibbs

I have an old sears 6" jointer. The jointer works fine. The fence does not hold. It clamps only at the front of the infeed table. If I am milling rough stock and want to hold a jointed edge against the fence, I will not get a square cut. There is no comparison to modern fences on 6" jointers. Has anybody retrofitted a sturdy fence to an old jointer? I would be satisfied if it was set only at 90 deg. Thanks. Jerry

Re: retrofittng jointer fence

#2

JL

Re: retrofittng jointer fence

JL

Wow - what an interesting thought. Table saws and band saws are easy. Unbolt the old fence rails and bolt a new set of rails on the tool - then attach the new fence.

Off hand, I would say, no such luck. Not much standardization between jointers of different types. Yes, a 6" is a 6", but they are all configured different ways. By the time you invested the money in machining a new one, you'd be halfway to the price of a new jointer.

Re: retrofittng jointer fence

#3

current thought

Jerry Gibbs

The design will be based on a table saw fence that also clamps at the far end. I will add a piece of slick faced 3/4 ply to the present fence that extends past the end of the outfeed table. I will bolt a piece of 2" angle iron across the back of the outfeed table and extending to the right. The extended fence will then clamp to the angle iron. Its worth a try and will cost nothing. Jerry

Re: retrofittng jointer fence

#4

Leo Cuellar

Re: retrofittng jointer fence

Leo Cuellar

If you take the locking handle apart, perhaps you may be able to add a thin washer in order to increase the clamping pressure & hold it tight?

Re: retrofittng jointer fence

#5

Re: retrofittng jointer fence

Keith Newton

I shared my shop with a friend who had one of those, but I don't recall how it was mounted. However, I was wondering if you couldn't drill out and tap for a larger bolt and knob, or whatever you turn to tighten it down.

I didn't care much for that jointer. It didn't have a movable out-feed bed.

Re: retrofittng jointer fence

#6

solution

Jerry Gibbs

angle iron across end of outfield table allows auxiliary fence to be clamped. significantly strengthens fence. I need a real jointer. Jerry