Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Advice needed - Newbie to Spraying

Posts

Advice needed - Newbie to Spraying

#1

Advice needed - Newbie to Spraying

Chad Pearson

I recently purchased a Rockler HVLP gun just to test the water on spraying. I would like to try out spraying water based lacquer but don't know where to buy it. My local paint store didn't have it. Can anybody give me advice on where to find a good water based lacquer?

Thanks,

Chad

Re: Advice needed - Newbie to Spraying

#2

Kittens Do It Instinctively


Re: Advice needed - Newbie to Spraying

#3

Sorry, allergic to cats

Chad Pearson

But if it was as easy as holding them up to the project I would be happy.

Re: Advice needed - Newbie to Spraying

#4

Urine trouble now, Colonel.


Re: Advice needed - Newbie to Spraying

#5

Re: Advice needed - Newbie to Spraying

GregMuller

Google General Finish. Thay have a good selection of water based finish's you can spray.

Re: Advice needed - Newbie to Spraying

#7

Aarghhh!

doug f, san clemente, ca

Oh, Colonel, it's so good to have you back.

Doug

Re: Advice needed - Newbie to Spraying

#8

Re: Newbie to Spraying - Target Coatings

mdclor

+1 on the Target EM6000. I am a novice at spraying and the 6000 lays down great with hardly any need for sanding.

Re: Advice needed - Newbie to Spraying

#10

general finish pre cat urethane

Bob Boswood

is what I just used on a set of kitchen cabinets. I'm no pro but this water based product was the best I have ever sprayed. No stinking solvents, clean up with hot water and soap. In the future anytime I want a durable waterproof finish this pre cat urethane with the cross linker is what I will use. Sprayed great right out of the can after straining. Got mine from woodcraft. I use a compressor and hvlp gun, but if you bought good equipment results should be the same.

Bob in AK.

Re: Advice needed - Newbie to Spraying

#12

See the colonel's comment above

Bill Houghton, Sebastopol, CA

I don't think you want any post cat urethane.

Re: Advice needed - Newbie to Spraying

#13

Re: Advice needed - Newbie to Spraying

Stephen Kirk

I've also shot the water based pre-cat urethane from the Earlex HVLP. Went on beautifully easy. I applied the sealer and sanded it down first. I was sold on the General finishes at that point. Like also said, soap and water cleanup, no nasty chemicals. I have just a garage shop, so the thought of having lots of chemicals didn't sit too well with me.

Re: Advice needed - Newbie to Spraying

#14

no nasty chemicals ????

Howard Acheson

I suggest you obtain a copy of the Material Safety Data Sheet (MSDS) for the waterborne finish you are using. You will find that there are some "nasty" chemicals in the mixture. Respirators are still recommended when spraying waterborne finishes.

Re: Advice needed - Newbie to Spraying

#15

respirator a must

Bob Boswood

The odors from water based is less offensive to the nose but the chemicals are just as harmful. You must wear a good tight fitting charcoal filtered respirator at the minmum when spraying any finish.