Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

poly finish help

Posts

poly finish help

#1

poly finish help

vamatt

After spending countless hours meticulously sanding and then a mineral spirits cleaning, I brushed on full strength poly unto walnut slab countertop. After letting it dry for ten minutes or so, I noticed splotching from some contamination (silicone maybe). I quickly wiped off the poly with cloth and then again with cloth and mineral spirits. I'm going to seal the top with shellac based sealer then use the poly. My question do I need to strip with chemicals before applying the sealer? The piece has been drying for 12 hrs, is dry, and the blotching is gone, but it looks like I put a coat of wipe on poly on it. So there might be residual poly in the pores. Any help is appreciated. Also does sealer affect the durability of a finish?

Re: poly finish help

#2

Re: poly finish help

Don Orr

I think what you have done is applied a poly seal coat to your piece. If the blotching is gone I might try another coat and see how it looks. I have a feeling you might be fine with what you have. Not an expert nor do I play one on TV.

Re: poly finish help

#3

Re: poly finish help

Dick Coers

Silicone contamination doesn't cause "splotching", it reduces the surface tension and the finish does not lay down in a smooth film. It looks a bit like the finish has holes in it, like severe orange peel. I suggest that the splotching was where the poly soaked in. It will take sanding if you want to remove that thin film now. But, I always like to start a poly finish with a thin first coat, which is similar to what you have now. Shellac has terrible water resistance. (Alchohol solvent mixes well with water, think gin and tonic.) If you scuff the dewaxed shellac, and add a good film on top of that, it should not decrease the film performance of the poly.

Re: poly finish help

#4

Re: poly finish help

Howard Acheson

Is this new work or are you refinishing an item? What have you done to prepare the surface for finishing?

Dewaxed shellac is a very water vapor resistant finish and works well as an initial sealer. It's also an excellent barrier coat if there is any contamination on the surface.

That said, under normal circumstances, a shellac initial coat is not required. Thinning the first varnish coat about 30% with mineral spirits works well. Let it dry completely and then apply your subsequent coats of varnish thinned about 10% with mineral spirits.

Depending on the natural figure in the walnut, it can appear to color somewhat unevenly but that's the way walnut works.

Re: poly finish help

#5

Re: poly finish help

Dick Coers

Water vapor yes, but not resistant to water sitting on it. A wet glass left on a shellac finish is trouble.

Re: poly finish help

#6

Re: poly finish help

Howard Acheson

Well, it's not a good idea to let water set on any finish for an extended period. However, a shellac film of two coats will stand up to liquid water for an hour or two. Water damage is not an instantaneous thing. Shellac will also stand up to a spilled martini for at least an hour. As a martini drinker, I can attest to that.

Re: poly finish help

#7

Re: poly finish help

vamatt

Thanks all for the comments. two sealer coats of shellac and three poly. we'll see how they stand up to daily cooking abuse and two kids under six. maybe i can post some picks when it all comes together.