Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

vacuum frame

Posts

vacuum frame

#1

vacuum frame

Steve Jenkins

Today I picked up a "vacuum frame". I got it for nothing but don't really know what it is for. I'm going to try to modify it to use for vac. veneering. It is about 48 x 60, aluminum frame. the top is hinged and flips up. the top is aluminum angle around a glass panel, not flexible. The bottom is plywood, sealed to another aluminum frame and about 2" from the top. there is a vac pump to evacuate the space between top and bottom but since the top is not flexible it won't suck down onto the veneer and panel. does anyone have any idea what this was used for? I'm really curious.

Thanks

Re: vacuum frame

#2

Almost sounds like

John in NM

A machine for vacuforming plastic sheet around a pattern. Usually there would be a vacuum box, a middle frame that is hinged and holds the plastic, and a heat box for softening the plastic. The hinge allows the user to quickly flip the sheet of plastic from the heat box to the vacuum box while still keeping it aligned.

Re: vacuum frame

#3

Re: vacuum frame

Robby Wright in San Marcos, CA

From your description, I think you have an exposure frame that is used for shooting artwork for screen printing and similar projects. The artwork is clamped in between the plywood and the glass and a vacuum is pulled. Then a camara takes the picture and the negative processed.

You could convert it real easy by replacing the glass with a piece of polyurethane or vinyl sheeting and adding seals around the edge of the frame if they aren't already there. You might need a sheet of vacuum netting to allow the air to get to the vacuum fitting(s).

Sounds like a good find if you have room for it.

Re: vacuum frame

#4

Re: vacuum frame

McKay

When I taught, I had a frame that sounds familiar, but it had vinyl on top and bottom. We would veneer flat stock. Worked just like a vac. bag, except the top would flip up. This was advantageous when working alone because you did not have to have four hands to hold the bag and insert the pieces to be glued down.

Re: vacuum frame

#5

Re: vacuum frame

Woodie49

Robby got it right. A friend of mine has one in his screem printing shop.

Re: vacuum frame

#6

Re: vacuum frame

Steve Jenkins

This morning I plugged it in and put a piece of 3/4mdf in it just to see what would happen. It pulled a good vacuum and the rubber membrane pressed the mdf up against the glass like I had hoped it would. Next step is to apply some glue and veneer to the mdf and try again. I'm thinking that the top glass will act as a platen. The isn't a lot of space between the glass and the rubber membrane but enough for 3/4 for sure, maybe 1". Thanks for all the info. I'll let you know how it works.

Steve