Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Making frame and panel doors question?

Posts

Making frame and panel doors question?

#1

Making frame and panel doors question?

Barry Irby

Finally he asks a question actually about wood working. :D

A friend wants to make some Shaker style Kitchen cabinet doors. His plan is to take stock that is about five inches wide and cut the slots for the panels on both edges and then rip them in two into strips about 2 1/4" wide. He wants to start with fairly long pieces, maybe 8'. I think this is a mistake. I think the pieces will warp after he rips them. I would cut them nearly to size, perhaps leaving them a 1/4" too wide and let them acclimate a while and then finish milling them.

What do you think? What sequence would you use?

Re: Making frame and panel doors question?

#2

I do it your way...

John in NM

I rough parts out just as you described, then size them down after they've done moving. Mostly I find they move when cut out here where it's usually dry as a bone, but a couple days settling is never a bad idea. If your friend is set on the 8' long strips, rough them out that way and cut to about 1" over length before final sizing.

If 10/4 stock is available, it can be ripped into door stiles, making nice rift or quartersawn material. Now and then I even find it worth shrinking the stiles to under 2" when I can only get 8/4.

Re: Making frame and panel doors question?

#4

Re: Making frame and panel doors question?

Rob Sandow

Cut each piece to final dimensions using standard techniques (jointer, planer, table saw, etc) then cut the slots for the panels. There really isn't even much, if any efficiency to be gained by doing it the way he describes, but plenty of potential for the final pieces to come out twisted or bent due to stress release after being cut to final size.

Re: Making frame and panel doors question?

#5

Re: Making frame and panel doors question?

John McGaw

I always cut stock slightly oversize and then let it sit for a while. Ripping is especially tricky if done late in the processing since it so often relieves stresses in the boards and lets them do nasty things. When using rough stock, which I almost always do, I joint and plane to slightly over-thick too and then reduce it as one of the last steps. Never but never do I try to work with long stock unless the job actually calls for it and there is no way around it -- there is just too much waste when jointing and planing long stock.

Re: Making frame and panel doors question?

#6

Re: Ditto plus

Larry Clinton At Frankfort, (Central) Indiana

I ALWAYS cut extra door rail and style parts, usually at least 1 part for each 2-4 of same size part. This allows for some parts warping too much to be used, grain pattern match or defects (which often doesn't show up until final routing or planing) and eliminates trying to do the re-setup to duplicate parts. The amount of extra parts increases when using certain woods (Oak, Elm etc.), and decreases when using others (Cherry, Walnut, etc.). I do the same when roughing out face frame parts, drawer fronts --.

Re: Making frame and panel doors question?

#7

Re: me, too.

Jim Toews

Ditto.

Re: Making frame and panel doors question?

#8

Re: Ditto plus

John McGaw

Yeah, I do that too although I didn't think to mention it. I've actually gone back several years later when I needed some new stuff in my kitchen and used the old parts rough cut when I built the cabinets. I think that I must still have parts on the shelf for a few more doors.