Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Advice needed -- drilling ivory

Posts

Advice needed -- drilling ivory

#1

Advice needed -- drilling ivory

AZ in Colorado Springs

A friend is making a replacement handle for a sword, and is using ivory. The handle will be about 4" long and 1" thick and maybe 1-1/2" wide. It requires a cavity all the way through that at one end is a 1/4" hole and at the other end is 1/4" by abuut 5/8" or 11/16".

I'm thinking that to make the cavity, we will bore a 1/4" hole all way through, and then bore a second hole, starting at the wide end, and angled to converge with the first hole at the other end -- think of a two sided angle, with the vertex at the end where a 1/4" hole is required.

The ivory (walrus tusk, in this case) doesn't appear to have any grain, but there is some sort of pith near the center of the piece we have.

My question is what are the pitfalls, if any, for boring holes in ivory? I'm thinking of using a brad point bit for both holes (if that bit is too short, I'll finish with a longer bit that I have that is not brad point), and I'll make a guide block as a visual aid for getting the correct angle on the second hole.

Also, the wide end of the cavity will need to be squared up. Any problems using a plain old bench chisel from the borg for that?

Thanks in advance

Andy

Re: Advice needed -- drilling ivory

#2

Re: Advice needed -- drilling ivory

Mark Mandell - Gone Round In New Jersey

If I'm reading you right Andy, you need to make a tapered bored to fit a tapered tang of the sword, with the 1/4" being the pommel end.

I think what you need to do is drill your 1/4" bore and then use a 3/16" rat tail rasp to taper the bore to fit the tang so that you preserve the 1/4" thickness. Walrus tusks are teeth, so the section up the middle was like the soft tissue and nerve of the tooth.

Re: Advice needed -- drilling ivory

#3

Re: Advice needed -- drilling ivory

John Lucas

I've never bored Ivory but have drilled out holes like that in other material. Mark is right. Drill one hole then enlarge it with files. I use a square file to do that kind of work.

Re: Advice needed -- drilling ivory

#4

Re: Advice needed -- drilling ivory

Brian Anderson Gunsmith

My advise would be to use slow rate of feed and fine toothed tools. Taking as small a bite as possible.

Re: Advice needed -- drilling ivory

#5

Drilling ivory -- clarification

AZ in Colorado Springs

It's not exactly a tapered bore, I don't think. The cavity required is a wedge shape, with a 1/4" round hole at one end (at the very end of the sword, where I thnk a pommel screws onto the protruding end of the sword casting) which expands toward the other end (and along the way transitions to squared sides) and emerges (at the end nearer the blade) as a squared-off opening of 1/4" by about 11/16".

I'll look at the other forums, as suggested. This piece of ivory was fairly expensive (my buddy bought it a few years ago) and we don't have any extra to practice on. Maybe I need to look for some ivory to practice on and get a feel for this.

Re: Advice needed -- drilling ivory

#6

Re: Drilling ivory -- clarification

Stuart Johnson

Practice on plastic or even wood until you have the steps down pat on how to make the taper and get a perfect fit. Then go to your expensive stuff.