I don't do this very often...
Joe in a Cleveland suburb
only about once every 18 months or so. I completed a project.
Not much of a project, but at least I did it.
Shaker Round table. Nothing too exciting. Just something I always wanted to make. Actually made two of them. One was a gift.
Cherry with varnish wiped on.
The table top was profiled using a scraper I made from a piece of BS blade. Worked ok. I kept trying various router bits but just kept making scrap table tops and starting over. The scraper thing turned out to be the quickest/easiest way.
I also used the router to do the DT's to receive the legs. If I were to make any more of these tables, I'd do them by hand. Setting up the router and jig seemed to take more effort than it was worth. Probably would have been quicker by hand (Like Roy Underhill in one of his episodes).
Not the greatest picture (cell phone), but thanks for looking.
]



