Plywood grain and shelves question?
JL
Most of the time when I use plywood for shelves, I usually rip the plywood and then crosscut it.
I have to make a number of shelves for the prop room of the playhouse. I figured on ripping 2 x 4 to get "2 x 2" to act as support for the shelves. I was going to assemble the 2 x 2 into "figure 8s" and cover it with a piece of 1/2" plywood 4' x 15 7/8". I was going to lag or screw the 2 x 2 onto four 2 x 4 uprights.
This got me to thinking - why rip? Why not just crosscut the 4 x 8 sheet of plywood? I would still end up with six shelves per piece of plywood. The plywood is fully supported by the 2 x 2 frame in any case.
Any good reason not to do it this way?



