Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Poly over paint?

Posts

Poly over paint?

#1

Poly over paint?

Tom Pilsbury (Chicago)

Made 2 small boxes from some leftover plywood and painted them with glossy black latex paint. They look pretty good but not as glossy as I expected. So can I hit them with a coat of water based poly? Will that make them nice and shiney? Or will there be problems with poly over paint? I've never done this before. It's not critical but I thought I'd ask you guys first just in case.

Re: Poly over paint?

#2

Jason Roehl in Lafayette, IN

Re: Poly over paint?

Jason Roehl in Lafayette, IN

Scuff sand them first--maybe 150 grit. Then you'll probably need more than one coat of waterborne poly, but it will look fine. I did it in a house where my customer had a wide and long bench/half wall that she wanted to have painted. I noticed after I painted it that within days it was scuffed up already (her kids would dump their book bags there). So I put a couple coats of waterborne floor poly on it. When I went back 4 months later to do some other work, it still looked like I had just done it.

Jason

Re: Poly over paint?

#3

Impossible to answer, so test

Bill Tindall

There are dozens if not hundreds of latex and varnish formulations and the manufactures offer no clue as to what is in them. You will need to test. If the coating seems to be ok take a razor blade and score a cross hatch about 1/16" apart. Apply tape and pull. How many squares pull off will give you some measure of adhesion.

Re: Poly over paint?

#4

Test, Test, Test

Mark Mandell - Gone Round In New Jersey

Aside from adhesion issues (shouldn't be a big problem if you scuff sand as mentioned, suggest finer grits 220-320) different waterborne clears will have different refractive properties in the final film, not to mention slight tints. Some will push your black into the cooler blue range while others will trend to the warmer ambers. What you see in the can won't answer the question because it's the refractive structure of the final film that determines the result.

Paint some scrap black, then apply your clear(s) in several applications to see what you'll get.

I've seen some lovely finishes where a black was used and then overcoated with clears; very deep and rich like automotive paints. You do need a very even surface on the black because the clear film will act something like a magnifier for things like brush strokes or lap marks in the base coat.

Re: Poly over paint?

#5

Sure . . .

steve mackay

Did a SPARTAN and SPRINT missile for Los Alamos a few years back. While I normaly don't paint my work and just put on 10 or 12 caoats of water poly, they insisted they have the black & white Cold War paint scheme. Came out well and still is (as far as I know). That nice, glassy look. My only beef was that the poly seemed to telegraph the wood grain after the paint seemed to cover it up. Might have been my imagination though. I hate paint.

Re: Poly over paint?

#6

Re: Poly over paint?

Howard Acheson

Did you use a latex interior wall paint or was it a waterborne acrylic? Waterborne acrylic paint is much harder and does not require any overcoating. Overcoating will not improve durability. Waterborne acrylic paint is nothing more than clear acrylic with lots of opaque pigment coloring added.

If you used an interior wall paint, it will be a very soft film and easily damaged. Just applying a clear acrylic waterborne on top will not improve the performance much. A hard finish applied on top of a soft finish is never a good idea.