Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Ebony Stain

Posts

Ebony Stain

#1

Ebony Stain

Marty

Last week I unfortunately dropped a large can of Ebony stain, on my shop floor. What a mess. I tried to "mop" it up with paper towels rags etc. Now I would like to get the residual stain off the floor. This is on unfinished concrete, What can I use? I have tried a wire brush,all that does is make concrete dust,but the stain remains. Paint Thinner? Mineral spirits? It has been suggested that I buy 10 or 15 more cans and just spread it around, nope was my answer. Can anyone help?

Re: Ebony Stain

#2

Re: Ebony Stain

Keith Newton

You will probably have to grind some of the surface off, then come back over it with a topping mix, but that may not perfectly match the rest.

Probably a cheaper / easier option would be to just plan on painting the whole floor.

Re: Ebony Stain

#3

JL

Re: Ebony Stain

JL

IMO, your best (and easiest) solution is painting the floor.

Re: Ebony Stain

#4

unsealed concrete is like a sponge

Dick Coers

That stain is likely very deep. If you must remove the stain, I would probably experiment with peroxide (industrial stuff from the pool supply) two part oxalic acid (wood bleach), or something that changes the color of the stain not remove it. Be careful and read all safety warnings. Some of that stuff is highly corrosive, and vapors could rust your machinery, let alone your lungs and sinus cavaties. Also check how it will react chemically with the concrete. You don't want a soft hole in the floor instead of an even color. I vote for camo stain job on the floor. Get some other colors and "spill" them in a random patterns. LOL!

Re: Ebony Stain

#5

Re: unsealed concrete is like a sponge

Howard Acheson

Just so there is no misunderstanding, there are three bleaches commonly used by woodworkers:

** Chlorine bleach--used to remove the color of dye type finishing stains

** Oxalic Acid--used to remove mineral stains from wood (black water stains, etc). Teak cleaner is a mixture of Oxalic Acid.

** Two part A/B bleach--used to remove or lighten the natural color of woods

Re: Ebony Stain

#6

Re: Ebony Stain

Ken Garlock North Texas

Hi Marty .

Several years ago I knocked over a container of PVC purple primer on the concrete outside the garage door. My solution was simple, soak the problem area in good, old, Clorox bleach. It took several treatments of apply bleach, let it soak in, wash it away as you use a steel-wire brush on the surface. Repeat until the surface is clear of the stain.

It is a no fun job.

Good luck,

Ken

Re: Ebony Stain

#7

Re: Ebony Stain

Bill Tindall

If the black is the result of a pigment you are screwed as the pigment will be carbon black and nothing will remove or bleach it. However, if the black is the result of dyes then full strength Chlorox bleach may 1. do nothing, 2. change the color to something even more objectionable, or 3. render it colorloss.

The strong caustic in this bleach may affect the finish on the concrete making it more dull.

For ease of sweeping and better light reflection for better visibility I would paint this floor some light color.

Re: Ebony Stain

#8

Just Go With It

Mark Mandell - Gone Round In New Jersey

My shop floor

has any number of applied graphics. I explain that it's actually a 4x porn mural but you have to be at an altitude of 4,000 feet to see it. :D

ps: Seal and then coat the floor with an epoxy in your color of choice. It will be far easier to keep the place clean.

Re: Ebony Stain

#9

Re: Just Go With It

Marty

Thank You one and all. I think I'll just go with it. I was planing on putting down,2x4's 3/4 plywood. A bit softer than the concrete and you can bet I'll put a finish on the plywood, and do my staining outside. This will just expedite the "next project"

Re: Ebony Stain

#10

Jackson Pollock would be so proud of you, Mark


Re: Ebony Stain

#11

The myth of wood floors

Bill Tindall

How can anyone's foot separated by sock, and shoe know if it is standing on cement or wood? Does anyone believe that wood is more compressible than cement when stressed by a 2 psi load (body weight divided by foot area).

Paint the floor and buy a squishy floor mat to stand on. The mat is a multitasker by shielding tools that roll off the bench from the effects of the concrete.

Re: Ebony Stain

#12

Re: Jack The Dripper

Mark Mandell - Gone Round In New Jersey

Sounds like great company, but I suspect I'd be more welcome (or not) among the spray-can guys lurking in the commuter rail yard. :D

Re: Ebony Stain

#13

Agree

George Colonel's Workshop-Havertown PA

Good Afternoon Marty,

Wood looks better to my eyes, but I have to agree with Bill about the "feel". No difference that I can tell, and I have both. Wood burns also, which I don't want. I'd paint. Save the money for other things, or send the surplus to me. :b

George