Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

unbending a atwist in BB ply

Posts

unbending a atwist in BB ply

#1

unbending a atwist in BB ply

Carol

This piece was flat. The plywood has been standing against a flat wall, not stored twisted in any way. Further I've had it for nearly a year in Arizona, moved it here a few months ago. It is 13x32 and it has twisted about 1/4" out of flat. It is super dry here - single digit humidity every day! I cut a second piece. Same problem. A new sheet is well over a hundred miles away. This is to be a shelf with ledgers, which did not pull it flat on the first piece.

What are my chances of soaking them, clamping them flat and having them stay reasonably flat? There are adjustable shelves, so no dado to lock them into. My thought was to clamp them flat and lay a well soak towel on the top. Let that dry, then flip it over and repeat. It would dry in 12 hours easy. If that looked like it wold be working, I could repeat it until it does. This shlef will be painted and eventually live in an air conditioned home in Yuma with others like it with goodness only knows what stacked on it.

Any thoughts?

Re: unbending a atwist in BB ply

#2

Re: unbending a atwist in BB ply

TomD

I think making it flat does not sound all that likely to work, you normally need to go in the opposite direction. And normally I just replicate the condition that caused the problem, but in reverse. I would examine the curve and mark it on a caul, then just clamp in the opposite direction. It probably won't take very long to get back to flat. The more time you have though, to check for backsliding and make corrections, the better.

Water can affect the dimensional purity of the panel. What it should not do is slip the glue, or the lignin. It will reduce the tensile fiber strength of the wood, which isn't really a bonus. So I don't think you will get anything out of wetting the wood.

There are activities like archery, where we just hand straighten stuff all the time, and it stays straight, and works great until the next tweak sends it off. This isn't a technology that all woodworkers are familiar with, but it works, is normally what caused the problem bend in the first place, and correcting it does not require doing anything more fancy than counter bending.

Re: unbending a atwist in BB ply

#3

Ellis Walentine

Not sure about the ledgers...

Ellis

.. or exactly what you mean by that, but the foolproof way to flatten or otherwise counteract distortion is with structural members that have enough engineering in them to overcome the problem. Sometimes, this even means crowning the ledgers or frames or whatever.

I wouldn't bother with the water treatment. Clamping flat won't help in any case. Over-clamping might work temporarily, but I really think you need to engineer a structural solution.

Ellis