Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Lefty-Righty Loosey

Posts

Lefty-Righty Loosey

#1

Lefty-Righty Loosey

Mark Mandell - Gone Round In New Jersey

With a motor that runs counterclockwise, should the arbor thread be a left or right hand thread to prevent loosening during use as grinding/buffing?

I think it should be a right hand thread.

Re: Lefty-Righty Loosey

#2

Re: Lefty-Righty Loosey

Butch...Mn

My right-tilt unisaw has an arbor that turns clockwise and has a left hand thread. Therefore, I believe that your assumptions are correct.

Re: Lefty-Righty Loosey

#3

Rick L

Re: Lefty-Righty Loosey

Rick L

A better way to think of it is the nut or collet loosens in the direction of rotation thus automatically tightening when running. A shaper typically uses a double nut to allow for dual direction.

Re: Lefty-Righty Loosey

#4

Re: Right Hand thread

Larry Clinton At Frankfort, (Central) Indiana

Easy way to explain - imagine holding the grinding wheel arbor in your hand and rotate the motor shaft CCW - the arbor should then screw on the shaft and tighten. (If you hold a standard RH bolt in your left hand and put a nut up to it and rotate the bolt CCW it will screw into the bolt.)