Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

French cleat question

Posts

French cleat question

#1

Bob

French cleat question

Bob

I am outfitting a new shop and looking for some storage solutions for the walls. I want to store my clamps on the wall but it needs to be adjustable left to right to accommodate any longer clamps as I add or subtract from the rack. My question is do you think 3/4" plywood attached to the wall as a french cleat would be strong enough to hold, say 8 pipe type clamps?

Re: French cleat question

#2

Re: French cleat question

Hal

3/4" should be OK. I have some pretty heavy items on French cleats made from 3/4" ply in my shop. I use at least 3" screws (McFeelys square drive) so they have a good bite into the studs. Hal

Re: French cleat question

#3

Bob

Re: French cleat question

Bob

Super, Thanks Hal. I think I will get on it later today I may post a photo as well.

Re: French cleat question

#4

Re: French cleat question

TomD

My shop has a french cleat running all the way around it. I have a pipe clamp rack that consists of a cleat and spacer on a piece of 3/4" ply which has a second piece of ply sticking out parallel to the floor, and mounted on top. That second piece of ply has slots in it that the clamps ride on. My cleat is mounted to my drywall by means of very hefty screws that catch the studs on 16" centers. They will carry a significant load.

I don't have a pic of the clamp rack, though in this picture you can see a clamp hanging from it way off down the wall. I has the orage jaw. But as you can see, the cleat will hold up even some lumber, and there is even more on there today. See the arrow? That block it is wedged under probably weighed 80 pounds when it was still wet: