Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

OT Anybody tried gluing a Plastic Chair?

Posts

OT Anybody tried gluing a Plastic Chair?

#1

OT Anybody tried gluing a Plastic Chair?

Barry Irby

Friend of mine bought a couple of the molded plastic chairs at an auction and one of them is broken. Though it was made of PVC and tried plumbers glue...nothing, did not touch it, zip. Turns out it is marine grade polypropylene. Anybody know a glue that will work? (I know the chair is cheap junk, but my pack rat gene has kicked in.)

Re: OT Anybody tried gluing a Plastic Chair?

#2

Re: OT Anybody tried gluing a Plastic Chair?

Dave Paine

Worth trying epoxy. Rough the surface with sandpaper then clean with acetone.

You do not state if this is a cosmetic repair or structural. I hope the former, although epoxy and fibreglass mat should work.

I did fibreglass mat with epoxy to fix a plastic cannister vacuum handle where the hose attached. Still holding.

I am not sure what type of plastic was used, but the first attempt with just epoxy did not hold.

Good luck.

Re: OT Anybody tried gluing a Plastic Chair?

#3

Yes

Mark Mandell - Gone Round In New Jersey

But found out the hard way that PVC cannot be glued with anything like a reliable, weight-bearing, bond.

I therefore "glued" the piece to the recycling bag and took the whole lot to the transfer station recycling pile.

Re: OT Anybody tried gluing a Plastic Chair?

#4

Re: OT Anybody tried gluing a Plastic Chair?

Ken Oakley-Sunny St. Cloud, Fla.

Probably the glue is worth more than the chair

Re: OT Anybody tried gluing a Plastic Chair?

#5

Re: OT Anybody tried gluing a Plastic Chair?

Gary Camp, Bend Oregon

A good ski shop may be able to repair it with a base welder. I know there are hot air plastic welders around I've never tried finding or using one. Can't imagine it would be as hard as Oxy-Acetelene, although I'm sure it would cost more than the chair is worth.

Re: OT Anybody tried gluing a Plastic Chair?

#6

Leo Cuellar

Re: OT Anybody tried gluing a Plastic Chair?

Leo Cuellar

Another thing to try, is drilling a few holes on each side of the break, Barry, and zip tie it together. Will work for a while.

Re: OT Anybody tried gluing a Plastic Chair?

#7

Agreed

Nat Robison

We're talking a white $10 chair from Walmart, right? I'm all for repairing and re-using but I wouldn't think much of getting rid of or recycling this chair......especially if the damage is in a weight-bearing area.