Shelix cutter for Delta DJ-20 Jointer
Randy Stukenberg
I just bought a used DJ-20 jointer and I am considering getting a helix cutter head for it. Does anyone have experience doing this or know where to buy the head?
Knowledge You Can Build On — Est. 1998
Shelix cutter for Delta DJ-20 Jointer
Randy Stukenberg
I just bought a used DJ-20 jointer and I am considering getting a helix cutter head for it. Does anyone have experience doing this or know where to buy the head?
I have one.
McKay
I installed my head and have really loved it. I found that Grizz had it cheaper than Byrd. (go figure) It was really easy to install if you have any mechanical skills.
Re: I have one.
Randy Stukenberg
Did you get new bearings too?
Re: I have one.
Dave Bair, Eaton Rapids, MI
The one I got for my JET included bearings; from their current catalog, it looks like their heads for the DJ-20 do NOT.
Re: Shelix cutter for Delta DJ-20 Jointer *LINK*
Paul Cates - Henderson, KY
A day or two after Christmas several years ago, I decided to purchase the Byrd head for the DJ-20. I didn't want to wait for holiday shipping if I didn't have to, so I called Holbren and ended up speaking with Mr. Holbren. He was very personable, and arranged for me to pick up the head from Byrd's factory, which is about 90 mi. from my house. I walked in Byrd's office, and at first didn't really notice Thomas Byrd leaning against the wall beause I thought he was an employee on break. But we got to talking, and he gave me a tour of the entire factory. I saw everything, including a machine that automatically made the inserts, and I talked to the guys that were installing the inserts into the Shelix head. I regret not taking my Woodcentral hat and a camera, but I never dreamed I'd get the grand tour by the owner!
If you're mechanically inclined, installing the head is easy, and yes, I installed new bearings. I recommend using thread-locker on the bolt that holds the pulley on the head because I didn't at first and the pulley came loose. Byrd's site does not have instructions for the DJ-20 but it does have an illustrated parts break-down if you need it.
Holbren
Re: Shelix cutter for Delta DJ-20 Jointer
Alan in Little Washington (NC)
I got the Shelix for my DJ-20 from Holbren as well. Woodnetters get a 10% discount but if you talk to Brian Gumper bgumpper@holbren.com I think they will give it to any WW forum member. Sometimes shipping is free if they have a promotion going.
Installation is simple and straight forward. If your bearings are old or you think you might bugger them during the swap get new ones. To swap the bearings go to any major chain autoparts store and get a free loaner bearing puller or just take both journals to a wheel and bearing shop and they'll do it for you quickly on their hydraulic equipment for a reasonable fee.
Compared to the job putting a Shelix on the typical 15" planer, putting it on a DJ-20 is a piece of cake!