Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Post office box bank question

Posts

Post office box bank question

#1

Post office box bank question

Bill Tindall

Are the boxes typically mitered. Will just a glued miter be sufficient. If a spline is desirable how does one make a spline that doesn't show on the front (a "stopped spline").

Re: Post office box bank question

#2

Dale Lenz

Re: Post office box bank question

Dale Lenz

Bill the ones I've seen, maybe 2-4 of them maybe, they are either box jointed or dovetailed. If I was going to miter the joints I'd use the showy "splines" actually the keyed feather like on my flag cases.

Your Choice

Re: Post office box bank question

#3

Re: Post office box bank question

Tony - Memphis

I bought one when I was a teenager and it appears to only be mitered. I doubt they did any fancy splines on it. I made a couple for my brothers (I worked at a college Post Office - up your way - think orange - and was given a few of the old ones) and I just used miters with no splines or anything. I may have added glue blocks on the inside - can't recall.

Tony

Re: Post office box bank question

#4

A.J. Hamler

Re: Post office box bank question

A.J. Hamler

A glued miter joint on one of those banks will be more than sufficient and plenty strong. They don't take much stress -- they spend 99.9% of their life sitting on a shelf -- and the risk of the joint not being strong enough is almost nil.

I make a lot of these, and I use a combination of rabbets and doweled butt joints. I rabbet in the bank bottom as well as the back panel (that alone would be strong enough to drop it off a house onto concrete and it would survive just fine), and butt-joint the top on and run dowels through the top. Then I arch the top, keeping the dowels visible for interest. Visible splines with miter joints would look nice, too. Here's what one of mine looks like:


One thing to keep in mind is that you have to create your opening carefully for the door to fit properly, which means if you're going to do miter joints you have to measure exactly, and always do a dry fit with the door before getting out the glue.

A.J.

Re: Post office box bank question

#5

thanks everyone

Bill Tindall

All good advice and ideas. I like the domed top, most attractive of the designs I have seen.

Re: Post office box bank question

#6

Re: thanks everyone

Barry Irby

This would be an easy job for a biscuit joiner, but I think it would not be necessary.

Re: Post office box bank question

#7

Re: thanks everyone

Bill Tindall

I own one but never had much success with it. It is enough to make one become a hand tool enthusiast (well almost).

Re: Post office box bank question

#8

Bob

Re: Post office box bank question

Bob

http://lumberjocks.com/closetguy He has it down pat/

Re: Post office box bank question

#9

Plans available

James Fox

Perhaps A.J. is too modest to mention it but he wrote an article with plans for the boxes in the first Woodcraft Magazine, published 05/01. A.J. has also included an updated set of plans & instructions for making the banks in his book, "Box Builder's Handbook."

I've made about 30 so far and given away all. They all seem to be enjoyed by the recipient. Thanks, again, A.J.

James

Re: Post office box bank question

#10

A.J. Hamler

Re: Plans available

A.J. Hamler

Glad you liked the box, James. You've made 30? You'll be catching up to me soon.

And thanks for the book plug!

A.J.