Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Strange TS fence problem

Posts

Strange TS fence problem

#1

Strange TS fence problem

Dustmaker Mike

Well on Friday and Saturday my BIL and I moved all tools from my basement into the new shop. For easy of moving the TS we took it all apart including taken the top off. We adjusted everything and made sure it was level and SQ. The TS is delta Unisaw.

Now my problem. When I move the Besie fence across the miter slot it hits the side and I have to lift it. I don't remember this happening before so what did I do wrong? Or do I need new slip pads for the bottom and where can I get them?

Re: Strange TS fence problem

#2

Re: Strange TS fence problem

Thomas S Stockton

Mike

One of two things are happening, the most likely is that when you put the fence back on the rail in front is just slightly lower than it was before so the fence is hitting. I don't have that fence but are the pads that the fence ride on adjustable?

the other possibility is that if there is a pad at the far end of the fence it needs to be adjusted or it fell off at some point. Could also be that the laminate face pieces on the fence shifted slightly at some point and are catching

Parts are available through delta and hopefully in stock.

Tom

Re: Strange TS fence problem

#3

Sounds

Mark Mandell - Gone Round In New Jersey

Like a vertical alignment problem. The fence mounting holes have a bit of play in them.

Take the fence off and the rail off.

Check your extension table to make sure it's dead level (front and back) with your saw top. You'll need a long (48") straight edge to do this.

When the 2 tables are dead-nuts even, reinstall the fence rail and check it with a combination square so that it is mounted at precisely the same distance down from the table top; should be close to 7/8". You'll need 4 reference points, 2 on each "table."

Put your fence back on and check your install. If you still get a "tick", remove the fence, loosen the rail mounts a smidgen, then tap the rail up evenly along the length. Re-tighten and recheck the fence.

Re: Strange TS fence problem

#4

Second the front rail needing to be checked

Dave Paine

Mike,

The original manual would have included a special piece of plastic or wood which would have looked like an "L" with a right angle notch protruding in the middle of the "L". Check the manual. The notch was to vertically position the front fence at the appropriate height.

The long part of the "L" is laid on the table, and the protrusion denotes the vertical position of the front rail. Check the position at both ends of the rail.

I have the black Bies fence which is aluminium extrusion. I think this is deeper than the earlier steel tubing. So my rail position may be different than yours.

The pads are likely special order, but they appear to be just UHMW type plastic, about 1/8in thick with two pins but could easily be glued to the fence. You could also use thin piece of a dense wood.

The pads appear to be for support when sliding the fence side to side. The locking mechanism on the front rail may take most of the stress when locked.

Re: Strange TS fence problem

#5

I still have the

Dustmaker Mike

instructions and all the stuff that came with it stored someplace so I should be able to find the little "L" shaped thing to set it. I forgot all about that. The pads on the bottom look good they do stand proud of the sides by a little bit. So I guess this is one time I should have read the instructions again(-;

Thanks All for the help

Mike